Glasdon C-Thru™ 48G Plastic Bottle Recycling Bin Assembly Instructions

Glasdon
Brand
Glasdon
Model
C-Thru™ 48G Plastic Bottle Recycling Bin
Type
Assembly Instructions

This manual is also suitable for

1.1 Ensure the illustration on the
key is uppermost.
1.4 Place a clear sack into the
body and hook over the rim
with approximately 2 inches
overhang.
1.5 Place the hood onto the body and
align the lock housing with the
front bobbin by turning the hood.
Push the hood fi rmly downward to
automatically lock the unit.
1.2 Push the key all the way into the
lock.(Do not turn the key). This
will automatically release the
locking mechanism.
1.3 With the key still in position,
turn hood counter-clockwise,
then lift hood off. Remove the
key.
2.1 Remove hood as (1) above,
remove sack if present. Insert
the plastic key into the lock.
2.2 Hold the body with both hands,
twist counter-clockwise and lift
away from the base. Remove the
key and keep safely.
2.3 To disassemble the body place
on a well-protected and soft
surface, joint uppermost. Push
down either side of the interlock
to disconnect the tabs, and allow
the sheet to spring fl at.
SAFETY NOTE: We would recommend wearing
safety gloves as the edges of
the interlocking mechanism
may be sharp.
C-Thru™RECYCLING UNIT
OPERATING AND ASSEMBLY INSTRUCTIONS
IMPORTANT NOTE: ENSURE ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO OPERATION.
1. LINER INSTALLATION
2. UNIT DISASSEMBLY
Lock housing
Front bobbin
1
2
1
1
22
AND C-THRU ARE TRADEMARKS OF GLASDON GROUP OR ITS
SUBSIDIARIES IN THE U.K. AND OTHER COUNTRIES
Issue 1 Aug. 2011 Stock no. C000/0237
©Copyright August 2011
Glasdon, Inc. reserves the right to alter specifi cations without prior notice. HA170/99
I A planned maintenance schedule of regular inspection is recommended,
replacing components as necessary.
I Replacement components are available direct from GLASDON, Inc.
I GLASDON, Inc. cannot be held responsible for claims arising from
incorrect installation, unauthorized modifi cations or misuse of the
product.
Remove ‘C Thru unit body’ following
fi gures 4 & 5 overleaf.
Hardware: -
1. One cable tie per unit.
2. Two spacers per unit.
3. LINKING CLUSTER ASSEMBLY
(b)
(a)
By setting GLASDON LOGOS on base
in identical positions, pre-drilled
connection holes will be aligned.
Pass cable tie through one of
the holes in the base, slide on
fi rst spacer, and pass through
corresponding holes in the next
base. Return through adjacent hole,
add spacer and pass through hole
in the fi rst base (a). Fasten cable tie
and pull reasonably tight (b).
  • Page 1 1
  • Page 2 2

Glasdon C-Thru™ 48G Plastic Bottle Recycling Bin Assembly Instructions

Glasdon
Brand
Glasdon
Model
C-Thru™ 48G Plastic Bottle Recycling Bin
Type
Assembly Instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents