2 - EN
EN
INSTALLATION MANUAL
Congratulations on the acquisition of your new RAIS or
ATTIKAproduct!Thisinstallationmanualwillensurethatyour
replaceinsertisinstalledcorrectlyandthatitwillprovideyou
withcomfortandpleasureformanyyearstocome.
IN GENERAL
Itisimportantthatthere-placeinsertiscorrectlyinstalled,in
considerationoftheenvironmentandpeople’ssafety.
The installation must comply with all local rules and
regulations, including those that refer to national and
Europeanstandards.Acertiedchimneysweepershouldbe
contactedbeforetheinstallationisstarted.
No unauthorised alterations may be made to the replace
insert.
GENERAL INSTALLATION REQUIREMENTS
Before the replace insert may be taken into use the
installationmustbereportedtoyourlocalchimneysweeper.
Theremustbeaplentifulsupplyoffreshairintheinstallation
roomto ensuregood combustion– ifrequired,throughan
AirSystemconnection.NB:Anymechanicalairextraction,for
exampleacookerhood,canminimisethesupplyofair.Any
airventmustbepositionedinawaythatensuresthesupply
ofaircannotbeblocked.
Thereplaceinserthasanairconsumptionof10–20m
3
/h.
Theoorstructuremustbeabletosupporttheweightofthe
replaceinsertandachimney,ifrequired.Iftheexistingoor
structuredoesnotmeetthisrequirement,suitablemeasures
mustbetaken(e.g.installationofaloaddistributionplate).If
indoubt,contactabuildingexpert.
National and local regulations must be complied with,
includingthesizeofthenon-ammableplatethatmustcover
theammableoorinfrontofthereplaceinserttoprotect
theoorfromfallenembers.
The replace insert must be positioned at a safe distance
fromammable material. Due to the risk of re,ammable
items (e.g. furniture) may not be positioned closer to the
replaceinsertthantheclosestpermitteddistancestatedin
theinstallationsection.Whendecidingwhereyoushallinstall
your RAIS/ATTIKA replace insert, you should think about
beingabletoheatotherroomsinthehome,soyougetthe
mostoutofyournewreplaceinsert.
When your replace insert is delivered, please check
it for any defects.
CHIMNEY
Thechimneymustbehighenoughtoensurethatthechimney
draught conditions are correct, i.e. –14 to –18 pascal. If
the recommended chimney draught cannot be achieved,
problemsfromsmokeescapingfromthedoormayarisewhen
lightingthere.Werecommendthatthechimneyisadapted
tosuittheueoutletspigot.Theueoutletspigotis150mm
indiameter.
Ifthedraughtisexcessive,itisrecommendedthatyouequip
thechimneywitharegulatingdamper.Ifaregulatingdamper
istted,youmustensurethatthereisafreeowareaofat
least20cm²attheclosedregulatingdamper.
Rememberthattheremustbefreeaccesstotheaccessdoor
onthechimney.
The length of the chimney, calculated from the top of the
replaceinsertshouldnotbelessthan3mandmustbeat
least80cmabovetheroofridge.Ifthechimneyisinstalledat
thesideofthehouse,thetopofthechimneymustneverbe
lowerthantheroofridgeortheroof’shighestpoint.
Note that there are often national and local regulations
relatingtohouseswiththatchedroofs.
Thereplaceinsertissuitableforconnectingtoasharedue
butwerecommendthatthein-feedispositionedsothatthere
isafree-heightdifferencebetweenthemofatleast250mm.
NB!
RAIS/ATTIKA recommends that the replace insert is
installed by an authorised technician. Please ask your
dealer for further information.
INSTALLATION MANUAL