3. Click Update and click REBOOT AP
Verify C1 AP/CPE Connection Status
For AP Mode
1. Go to Status > System
2. If WAN IP Address shows 0.0.0.0, check the Internet connectivity and logon info. If
not, WAN connection is successful
For CPE Mode
1. Go to 2.4GHz Association AP
2. If Connection Status shows Active, WAN connection is successful. If it shows
Inactive, check SSID, Authentication and Cipher mode provided by ISP
3. To reset TCP/IP Settings
Click Start > Control Panel and double click on Network Connections
4. Right click on the Local Area Connection and click Properties.
5. Double click Internet Protocol (TCP/IP)
6. Select Obtain an IP address automatically Click OK to close the Internet Protocol
(TCP/IP) Properties and click OK again to close the Local Area Connection
Properties