YOKOGAWA TS User manual

Type
User manual
Users
Manual
Mounting and Connecting
TR and TS Hour Meters
Yokogawa Corporation of America
2 Dart Road Newnan, Georgia U.S.A. 30265
Tel: 1-800-258-2552 Fax: 1-770-254-0928
IM 61A00A-01E-A
©Copyright May 1, 2003
1st Edition 5/1/03 1M
TS Series (square face)
Select the mounting configuration from below to determine panel cutout size. Then see opposite page for
outline dimensions.
Model TS-xxxxAx (No bezel-use outline 1, if bezel ordered- use outline 2 or 3).
Model TS-xxxxCx (use outline for mounting option C).
Model TS-xxxxDx (no cutout required. This mounts on DIN rail).
Model TS-xxxxFx (use outline 1 only).
Model TS-xxxxGx (No bezel-use outline 1, if bezel ordered-use outline 2 or 3).
TR Series (round face)
Select mounting configuration below to determine panel cutout dimensions. Then see opposite page for
outline dimensions.
Model TR-xxxxAx (use outline for mounting option A).
Model TR-xxxxCx (use outline for mounting option C).
Model TR-xxxxHx (use outline for mounting option H)
Electrical Wiring
If you have selected combination terminals, or will use the screw terminals for connection, please
observe the following precautions:
1) Use AWG #20 to #26 stranded wire
2) Make sure wire is stripped back 3/8" and wire strands are twisted tight or soldered
3) Loosen non-captive screw no more than 5 full turns
4) Insert wire between pin and clip, then tighten securely,
If you are using the pin connection. Use a 1/4" quick connect female spade lug that has been properly
crimped to wire leads. Slide all the way onto the pin terminal.
Please observe polarity symbols molded into case above terminals.
2
IM 61A00A-01E-A
50.5+1
50
55
41
58
Aluminum clamp for TR Series
Mounting A
Cutout 51mm diameter (2.01”)
71+2
42 19
58
80
2
Anti-vibration boot and clamp
Mounting C
Cutout 71mm diameter (2.80”) for TR and TS (square outline not shown)
72
64.3
3.8
120°
32
58
Three screw front mounting for TR Series
Mounting H
Cutout 58mm diameter (2.28”)
45.5 ± 0.2
(1.79 ± .01")
ø51
(2.01")
ø50.5 ± 0.2
(1.99 ± .01")
45.5 ± 0.2
(1.79 ± .01")
Panel Cutout for TS Series
123
  • Page 1 1
  • Page 2 2

YOKOGAWA TS User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI