NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
1
KIT CONTENTS
• (1) ea. Safety Guard
• (2) ea. Mounting Brackets
• (2) ea. Spring Nut Clips
• (2) ea. Washer Screws
REQUIRED TOOLS
• Phillips Screwdriver
NOTE: This procedure requires two people.
GENERAL INFORMATION
This optional Safety Guard is designed to reduce the risk of burn injury
associated with incidental contact with the glass front on the fireplaces
listed in Table 1 (below) when it is installed and used in accordance with
both these installation instructions and the warnings, precautions, and
instructions included in the INSTALLATION INSTRUCTIONS and CARE
AND OPERATION provided with your appliance.
NOTE: Improper or repeated installation and removal of the
optional Safety Guard could scratch, dent, or otherwise deface
the metal frame that surrounds the glass front on the appliance.
HEARTH PRODUCTS
KITS AND ACCESSORIES
P/N 506019-70, Rev. A
11/2015
MONTEBELLO® GAS FIREPLACE
SAFETY GUARD KIT
INSTALLATION INSTRUCTIONS FOR SAFETY GUARD KIT
FOR USE ON MONTEBELLO® GAS FIREPLACE MODELS LISTED IN TABLE 1
Figure 1
Front Glass
Panel
INSTALLATION INSTRUCTIONS
NOTE: This procedure requires two people.
Step 1. If the fireplace is on, turn it OFF. Allow it to cool completely.
BEFORE CONTINUING, FIREPLACE MUST BE OFF AND COLD!
Step 2. See Figure 1. Remove the two existing screws from the top of
the Front Glass Panel.
NOTE: After removing screws, one person must hold the
glass panel in place (to prevent it from falling forward and
breaking), while another person completes the installation.
NOTICE
• READ ALL STEPS BEFORE STARTING INSTALLATION.
• THESE INSTRUCTIONS MUST BE LEFT WITH THE APPLIANCE.
• ALL WARNINGS, PRECAUTIONS, AND INSTRUCTIONS IN THE
INSTALLATION INSTRUCTIONS AND CARE AND OPERATION MANUALS
PROVIDED WITH THE APPLIANCE ALSO APPLY TO THESE INSTRUCTIONS.
• IF YOU ENCOUNTER ANY PROBLEMS, NEED CLARIFICATION OF THESE
INSTRUCTIONS, OR ARE NOT QUALIFIED TO PROPERLY INSTALL THIS KIT,
CONTACT YOUR LOCAL DISTRIBUTOR OR DEALER.
Remove two existing screws.
CAUTION
INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!
Hot Fireplace Will Cause
Severe Burns
Never Allow Children to
Touch Glass or other Fire-
place Parts
WARNING
Figure 2
Front Glass
Panel
Figure 3
IMPORTANT! After removing screws, hold
Glass Panel in place so it will not fall out.
Step 3. See Figure 2. Insert the back lip of each Mounting Bracket
(without the hole) under the bottom edge of the Glass Panel.
Step 4. See Figure 3. Attach one Spring Nut Clip (with straight edge
facing front and down) to the front lip of each Mounting
Bracket, and then align the holes.
Insert back lip of each Mounting
Bracket (without hole) under
bottom edge of Glass Panel.
Attach Spring Nut Clips
(straight edge facing front and
down) to Brackets; align holes.
MONTEBELLO® SAFETY GUARDS
Fireplace Application
Montebello Fireplace Model Safety Guard
Cat. No.
Safety Guard
Model No.
MontebelloDLX40,
DRC/DRT6340, LSM40-2 H8249 SG-13
MontebelloDLX45,
DRC/DRT6345, LSM45-2 H8251 SG-15
Table 1
Mounting Bracket
(with hole in front)
Spring Nut Clip