2. Computers & electronics
  3. Cameras & camcorders
  4. Camera accessories
  5. Camera kits
  6. Altronix
  7. eBridge1PCTX
eBridge1PCTX

Altronix eBridge1PCTX, eBridge4PCRM Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Altronix eBridge1PCTX Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
eBridge4PCRM - 1 -
PLUS
Overview:
The eBridge4PCRM and eBridge1PCTX are CAT5 to Coax cable Ethernet adapters/Media converters that deliver data and
power over the coax cable in a PoE+ compliant format. The paired set enables fast 10/100Base-T Ethernet digital com-
munication to be transmitted over Coax cable. An eBridge4PCRM receiver is powered by a a UL Listed limited power
source, PoE midspan or endspan product, such as a NetWay8M and NetWay16M and sends its power over the coax to the
eBridge 1PCTX transmitter under PoE protocol. This enables the eBridge4PCRM to be used in a managed manner, allow-
ing for remote camera reset. The eBridge1PCTX in turn delivers that PoE+ compliant power to a PoE enabled camera or
IP device. The eBridge4PCRM will not deliver power to non compliant devices, thus avoiding damage to improperly con-
nected analog cameras. These plug and play units facilitate system upgrades from analog to IP cameras/devices utilizing
existing legacy Coax and eliminating the costs and labor associated with installing new network cabling. In addition, data
transmission and power over the Coax is possible up to 500m in comparison to 100m Ethernet maximum distance (see
Maximum Length of Coax Type vs. Camera Power/PoE Class, pg. 3). A maximum range from head end to the PoE camera/
device is 610m taking into consideration that up to 100m of structured cable may be deployed at each end.
Features:
Agency Listings:
• UL/CULListedforInformation
Technology Equipment (UL 60950-1).
• CEapproved.
• C-Tickcompliant.
Input:
• Poweredbya UL Listed limited power source,
PoE midspan or endspan.
Ethernet:
• Connectivity:RJ45,auto-crossover.
• Wiretype:4-pairCAT5orbetterstructuredcable.
• Distance:upto100m.
• Speed:10/100BaseT, half/full duplex, auto negotiation.
PoE compliant to IEEE 802.3af (15W) and PoE+
complianttoIEEE802.3at(30W)Deliveredto
camera by eBridge1PCTX. Power provided by
eBridge4PCRM to eBridge1PCTX by PoE protocol.
• Throughput is rated to pass 25mbps of data at
distances up to 500m. With proper headend
equipment this supports Megapixel,HD720,HD1080.
Coax:
• Distance:upto500m(see Maximum Length of Coax
Type vs. Camera Power/PoE Class, pg. 3) for power
delivery of coax.
• Connectivity:BNC,RG-59/Uorsimilar.
LED Indicators:
• eBridge4PCRM:
BlueLED-Coaxlinkconnection.
Green-PoEON.
Green-PowerON.
LED Indicators (cont’d):
• eBridge4PCRMandeBridge1PCTX:
YellowandGreenLED(RJ45)IPLinkstatus,
10/100Base-T/active.
• eBridge1PCTX:
BlueLED-Coaxlinkconnection.
GreenLED-PoEfromeBridge4PCRM.
Environmental:
• Operating Temperature:
eBridge4PCRM: -- 4ºF to 120.2ºF (-- 20ºC to +49ºC).
eBridge1PCTX: --- 4ºF to 120.2ºF (-- 20ºC to +49ºC).
• Storage Temperature: -- 22º to 158ºF (--30ºto+70ºC).
• Humidity:20to85%,non-condensing.
Functions:
• Autodetectionandprotectionoflegacy
non-PoE cameras/devices.
Applications:
• RetrofitdigitalIPcamerasinananalogCCTV
installation.
• WorkswithMegapixel,HD720,HD1080andVGA
(SD)cameras(see note, pg. 2).
• ExtendNetworklinkdistanceinanindustrial
environment over 610m (see note, pg. 2).
• UpgradedeployedCCTVCoaxtoadigitalnetwork
in Retail, Hospitality, Arenas, Casinos, Airports,
Schools,Hospitals,Transportation,etc.
Mechanical:
•Dimensions(HxWxDapprox.):
eBridge4PCRM:
1.7” x 5.25” x 9.25” (43.8mm x 133.35mm x 235mm)
eBridge1PCTX:
1” x 2.5” x 4.375” (25.4mm x 63.5mm x 111.125mm)
eBridge4PCRM - IP and PoE+ over Coax Solution
Operates with eBridge1PCTX Transceiver.
Installation Guide
Rev. 032113
I.T.E. 43KC
Z1409
- 2 - eBridge4PCRM
Installation Instructions:
WiringmethodsshallbeinaccordancewiththeNationalElectricalCode/NFPA70/ANSI,andwithalllocalcodesand
authorities having jurisdiction. Wiring should be UL Listed and/or Recognized wire suitable for the application.
eBridge1PCTX and eBridge4PCRM are not intended to be connected to outside plant leads and should be installed indoors
within the protected premises. eBridge1PCTX and eBridge4PCRM are intended for indoor use only.
1. eBridge4PCRMinstallation:
a. Affix rubber pads to eBridge4PCRM for shelf installation (Fig. 4, pg. 4).
Unitshouldbemountedinproximitytoethernetswitch/network,NVRorvideoserver.
b. ConnectstructuredcablefromethernetmidspanorendspandevicetoRJ45jackmarked[10/100BaseT]
(Fig. 2, pg. 3).
c. ConnectCoaxcabletoBNCconnectormarked[Coax](Fig. 1, pg. 2).
2. eBridge1PCTXinstallation:
a. Secureunittodesiredmountingsurfacewithaproperfasteningdeviceutilizingthecase’smountinghole.
Unit should be mounted in proximity of camera/device.
b.ConnectstructuredcablefromIPcamera/devicetoRJ45jackmarked[10/100BaseT](Fig. 2, pg. 3).
c. ConnectCoaxcabletoBNCconnectormarked[Coax](Fig. 2, pg. 3).
Note:TheeBridge4PCRMisdesignedtoaccommodateMegapixel,HD720,HD1080andVGA(SD)cameras.Itisimpor-
tant to note that some high resolution and high frame rate cameras may demand faster headend processing ability, such as
a PC graphics card to present a quality image. If the headend processing equipment is insufficient in speed, the image may
show pixelation and latency. It is advisable to pre-test system if unsure. Alternatively, frame rate and resolution may be
reduced to accommodate system equipment.
Fig. 1
eBridge4PCRM
10/100
Base-T
Structured
Cable from
midspan/endspan
Data In
Coax
Cable from
eBridge1PCT or
eBridge1PCTX
Front Panel
Back Panel
eBridge4PCRM - 3 -
Ethernet Switch
NetWay8M - Front Panel
+ PoE --
SHUTDOWN
Local Area Network (LAN)
or Laptop connection
PoE Camera
PoE Camera
PoE Camera
PoE Camera
PoC (PoE+ over Coax)
500m max.
PoC (PoE+ over Coax)
500m max.
PoC (PoE+ over Coax)
500m max.
PoC (PoE+ over Coax)
500m max.
100m max.
100m max.
100m max.
100m max.
PoE compliant
100m max.
PoE compliant
100m max.
PoE compliant
100m max.
PoE compliant
100m max.
Coax
Structured Cable
Legend:
eBridge1PCTX
eBridge1PCTX
eBridge1PCTX
eBridge1PCTX
eBridge4PCRM
Green LED
indicates
Power
Structured
Cable from
IP Camera/Device
Blue LED
indicates
Coax Connection
Coax
Cable from
eBridge4PCRM
Fig. 2 eBridge1PCTX
Multiple PoE camera connection:
Fig. 3
- 4 - eBridge4PCRM
Altronix is not responsible for any typographical errors.
14058thStreet,Brooklyn,NewYork11220USA,718-567-8181,fax:718-567-9056
website:www.altronix.com,e-mail:[email protected],LifetimeWarranty,MadeinU.S.A.
IIeBridge4PCRM H01N
MEMBER
Shelf Installation
1 - Position and affix rubber pads (C) (included) at each corner on the bottom of the unit (Fig. 4).
2 - Place unit in desired location.
Fig. 4
Left Side
Rubber Pad
Mounting Hardware (Included):
Four (4) rubber pads.
C
B
A
C
Technical Specifications:
Parameter Description
Connections BNCforCoaxlink.RJ45forethernetlink.
Input power
requirements
Midspan or endspan port connected.
Indicators
Blue:CoaxLink.
Yellow(RJ45connector):On-Link,Off-NoLink,Blinking-Activity.
Green(RJ45connector):On-100Base-TX,Off-10Base-T.
Green:Power.
Environmental
Conditions
OperatingAmbientTemperature:UL60950-1
eBridge4PCRM: -- 4ºF to 120.2ºF (-- 20ºC to +49ºC).
eBridge1PCTX: --- 4ºF to 120.2ºF (-- 20ºC to +49ºC).
Relativehumidity:20to85%,non-condensing.
StorageTemperature:-- 22º to 158ºF (--30ºto+70ºC).
OperatingAltitude:--1000to6,561.679ft.(-- 304.8 to 2000m).
Regulatory
Compliance
UL/CUL Listed for Information Technology Equipment (UL 60950-1).
CE approved. C-Tick compliant.
Weights (approx.) Product:1.35 lbs. (0.61 kg) Shipping:1.7lbs.(0.77kg)
Maximum Length of Coax Type vs. Camera Power/PoE Class:
Camera
Power/
PoE Class
Coax Type
RG59/U - 23AWG RG59/U - 22AWG RG59/U - 20AWG RG59/U - 18AWG RG6/U - 18AWG
Max. Length (meters)
13W/0 260.6 335.3 500 500 500
4W/1 500 500 500 500 500
6.5W/2 500 500 500 500 500
13W/3 260.6 335.3 500 500 500
19W 152.4 198.1 315.5 500 500
25W 118.9 150.6 239.3 500 365.8
/