3
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
• Before you begin installing the light kit, disconnect the power by removing fuses or turning off the
circuit breakers.
• Make sure that all electrical connections comply with local codes, ordinances, the National
ElectricalCode,andANSI/NFPA70-199.Hireaqualiedelectricianorconsultado-it-yourself
wiring handbook if you are unfamiliar with installing electrical wiring.
• The net weight of the light kit is less than 4.4 lbs.
LISTED FOR DAMP LOCATION
Federal regulations require ceiling fans with light kits manufactured or imported after January 1, 2009,
to limit total wattage consumed by the light kit to 190W. Therefore, this light kit is equipped with a
wattage limiting device.
DANGER:
• For your protection and safety, carefully read and understand the information provided in this
manual completely before attempting to assemble, install or operate this product. Failure to do so
couldleadtoelectricalshock,reorotherinjuriesthatcouldbehazardousorevenfatal.
• DONOTconnectthisxturetoanelectricalsystemthatdoesnotprovideameansforequipment
grounding.Neveruseaxtureinatwo-wiresystemthatisnotgrounded.Installingaxtureinto
anelectricalsystemnothavingapropergroundingmeanscouldcausemetalpartsofthexture
tocarryelectricalcurrentsifanyofthexturewires,wireconnectionsorsplicesweretobecome
broken,cutorlooseduringthemountingornormaloperationofthexture.Underthiscondition,
anyonecomingincontactwiththexturewouldbesubjecttoelectricalshock,whichcouldcause
seriousinjuryordeath.
• DONOTconnectthebareorgreeninsulationxturegroundwiretotheblack(hot)current-carrying
wireorthewhiteneutralhousewire.Connectionofthebareorgreenxturegroundwiretothe
blackorwhitehousewiresmaycausemetalpartsofthexturetocarryelectricalcurrents.Under
thisconditionanyonecomingincontactwiththexturewillreceiveelectricalshock,whichcould
causeseriousinjuryordeath.
• DONOTdamageorcutthewireinsulation(covering)duringinstallationofthexture.DONOT
permit wires to contact any surface having a sharp edge. To do so may damage or cut the wire
insulation,whichcouldcauseseriousinjuryordeathfromelectricalshock.
WARNING:
• All electrical connections must be in agreement with local codes and ordinances, the National
Electric Code (NEC) and ANSI/NFPA 70-1999. Contact your municipal building department to learn
aboutyourlocalcodes,permitsand/orinspections.Riskofre-mostdwellingsbuiltbefore1985
havesupplywireratedfor140°F.Consultaqualiedelectricianbeforeinstallation.
• Toavoidpersonalinjury,theuseofglovesmaybenecessarywhilehandlingxturepartswithsharp
edges.
• DONOTsuspendanyxturebythehousewires.Axturemustalwaysbemounteddirectlytoa
ceiling fan that is mounted directly to an outlet box. Wire connectors will not support the weight of a
xture.Suspendingaxturebythehousewiresandwireconnectorswillresultinthexturefalling,
withthepossibilityofpersonalinjuryandthedangerofelectricalshockorre.
• Toreducetheriskofre,electricalshock,orpersonalinjury,eachwireconnectorusedwiththis
light kit should accept only one 18-gauge wire from the light kit and one 18-gauge wire from the
ceiling fan. If there are three or more wires to connect or any of the wires is larger than 18 gauges,
consult an electrician for the proper size wire connectors to use.