First Time Use
Charging the Baery
The BH-C26 Headphones have a built-in, rechargeable lithium-polymer baery. To avoid
damage, do not aempt to remove the baery. The full performance of the baery is achieved
aer two or three charging-discharging cycles. Charge the baery fully before first use.
1. Connect the USB cable to the headphones.
2. Connect to the correct outlet (wall, computer, car charger).
3. When the charger is connected to the headphones, the red indicator light will turn on.
Note: Charging the baery fully may take up to 2 hours.
4. When the baery is fully charged, the red indicator light will turn off. Disconnect the charger
from the headset and the outlet. The headset is ready for use.
Note: Overcharging could reduce the life of the baery. A charged baery will lose its capacity
if it is not used on a regular basis.
Important!
Ensure that the baery is fully charged if the headphones are not used for a long period of
me. To avoid a complete discharge of the baery, charge the headphones at least every six (6)
months.
Baery Notes
• A fully charged baery provides up to four (4) hours of talk-me, three (3) hours music
playback, and up to seven (7) hours of standby me. Talk and standby mes vary depending
on mobile phones or other compable Bluetooth® devices, sengs, styles, etc.
• When the baery power is low, the headset will beep every 30 seconds and the red indicator
light will flash every seven (7) seconds.
• When using with your iPhone, an addional baery meter feature will display the remaining
baery on your phone’s touch screen.
Pairing with your Phone
1. Place the headphones in close range of a Bluetooth®-enabled mobile phone.
2. Press and hold POWER buon for three (3) seconds. Unl indicator lights flash blue and red.
3. Set your mobile phone to pairing mode (as explained in operang instrucons for your
phone) and search for Bluetooth® devices.
4. Select "Vivitar HP" from the list shown on your phone.
5. If requested, enter the PIN code "0000" and confirm the entry. Once the pairing is successful,
the BH-C26 connects to your phone automacally before switching to standby mode. The
indicator will blink blue twice every three (3) seconds.
Note: If pairing is not completed within two (2) minutes, the headset will enter standby mode.
If this happens, turn the headset off and repeat the pairing steps above.