HANECO TRIPROOF20W06 Installation guide

Brand: HANECO

Model: TRIPROOF20W06

Type: Installation guide

Thanks for choosing our TRIPROOF batten series products.

We strongly recommend that you read this manual carefully before installation.

Installation Instructions

TRIPROOF SERIES

HANECO LED BATTEN INSTALLATION GUIDE

7-9mm

411mm

800mm

1000mm

1. Switch oﬀ power.

Isolate the electrical supply near location

so as not to cause electrical hazard.

2. Measure hole positions on mounting surface.

Fasten brackets to mounting surface.

3. Release clips on side of ﬁtting and remove diﬀuser.

5. Unlock and remove gear tray.

6. Wire as shown.*

4. Knock-out or cut out holes as necessary

to install cables.

9. Replace gear tray and diﬀuser.

Fasten anti-vandal screws if required.

10. Clip ﬁtting onto brackets. 11. Test the installation in accordance

with the wiring rules and regulation.

Switch on power.

TRIPROOF20W06

TRIPROOF40W12

TRIPROOF60W15

* Wire as shown for EMDD and DALI models

For Intellisensor models, see attached

leaﬂet for setup guide.

Ecoswitch models got to step 8.

All other models go to step 9.

8. Toggle switch left for 40W output.

Toggle switch right for 20W output.

• The luminaire must be installed by professional electrician.

• Switch power o when wiring the luminaire.

• Ensure input voltage conforms to the voltage range of product.

• Ensure wires are securely connected.

• Before switching on, ensure that all the wiring is correct.

• The warranty is void if product is not installed according to the instructions.

WARNING

For more information

www.haneco.com.au

1300 001 LED

Last updated 27/06/23

HANECO TRIPROOF20W06 Installation guide

HANECO TRIPROOF20W06 Installation guide

HANECO TRIPROOF20W06 Installation guide

Other documents