Giken Trastem AIO360 User manual

Brand
Giken Trastem
Model
AIO360
Type
User manual

This manual is also suitable for

Giken Trastem AIO360 is a people counting sensor that can be used to track the number of people entering and leaving a room or building. It can be installed on the ceiling and is powered by Power over Ethernet (PoE) or a 24 VDC power supply. The sensor has a LAN port for connecting to a network and an IP address reset switch for resetting the IP address of the sensor. The sensor also has an operation lamp that lights up in green during operation and blinks in red (IN) or green (OUT) every time a person is counted.

Giken Trastem AIO360 is a people counting sensor that can be used to track the number of people entering and leaving a room or building. It can be installed on the ceiling and is powered by Power over Ethernet (PoE) or a 24 VDC power supply. The sensor has a LAN port for connecting to a network and an IP address reset switch for resetting the IP address of the sensor. The sensor also has an operation lamp that lights up in green during operation and blinks in red (IN) or green (OUT) every time a person is counted.

AIO360G
Installation Manual
□Name and Function of Each Part
Sensor with the cover attached Sensor with the cover removed
②LAN/PoE Port
A power over Ethernet switching hub (PoE-HUB) is
connected via LAN cable.
③IP Address Reset Switch
The IP address of the LAN registered in the
sensor can be initialized by holding down this
switch for 5 seconds or longer.
①Operation Lamp (LED)
Note:The default IP address is “192.168.0.249/24”.
The lamp lights up in green
④DC Jack
during operation, and blinks in
An AC adapter specified by
red (IN) or green (OUT) every
Giken Trastem is connected
time a person is counted.
□Installing the Sensor on the Ceiling
□Attaching the Cover
① The direction of the "FORWARD" arrow is
①Check the position of the operation lamp
captured on the upward direction of the screen.
and determine the orientation of the cover.
② Secure the sensor to the ceiling at 4 positions
②Fit the cover into the body.
using appropriate screws.
③Make sure that the two claws
③ Connect the LAN cable.
on the body are covered.
□Network and Count Settings
Connect the sensor to a PC via the LAN and configure the sensor using a browser (Internet Explorer).
Network settings: IP address, subnet mask, default gateway, etc.
Count settings: Installation height, count area, count direction, etc.
Other settings: Time setting, data transfer setting, etc.
Notes: 1. The default IP address is “IP: 192.168.0.249/Subnet Mask: 255.255.255.0”.
2. For details of the settings, refer to the relevant instruction manual.
□Specifications
Power-over-Ethernet:IEEE802.3af Class 0 or 24 VDC(DC jack), MAX.10W
Indoor use, Temperature 0 to 50℃, Humidity 30 to 85%(no condensation)
W153.3mm × D138.4mm × H59mm　approx.350g
CAT5 or higher,maximum wiring length 100m
10/100Base-T(X)、Protocol︓TCP/UDP(IPv4)、ARP、ICMP、SNTP、FTP、HTTP
In and OUT count data recorded every minute.
Approx. 100 hours(Electric double layered capacitor)
Installation Manual, Safety Manual(this manual)
Giken Trastem Co., Ltd.　 (Headquaters) 98, Nishi-Dankawara-cho, Takeda, Fushimi-ku, Kyoto, 612-8429 Japan Tel: +81-75-641-6000
Sensor Dimensions and Weight
Operating Environment
Power Supply
Accessory
Power Interruption Back up for Clock
Recorded Data
LAN Specifications
LAN Wiring
①
③
②
②
②
②
①
②②
③
  • Page 1 1

Giken Trastem AIO360 User manual

Brand
Giken Trastem
Model
AIO360
Type
User manual
This manual is also suitable for

Giken Trastem AIO360 is a people counting sensor that can be used to track the number of people entering and leaving a room or building. It can be installed on the ceiling and is powered by Power over Ethernet (PoE) or a 24 VDC power supply. The sensor has a LAN port for connecting to a network and an IP address reset switch for resetting the IP address of the sensor. The sensor also has an operation lamp that lights up in green during operation and blinks in red (IN) or green (OUT) every time a person is counted.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents