UNISENSE High Performance Microsensors Operating instructions

Hello, I've reviewed the instructions for packing microsensors. This document explains how to use membrane inlays and plastic clips to secure the sensor and its wires during shipping. I'm ready to answer any questions about this process based on the document.
How should the first membrane inlay be placed?

Where should the sensor wires be placed during the packing?

How should the second membrane inlay be placed?

Instructions for correct packing of microsensors

1. Placing the first membrane inlay

Place one membrane inlay in the box with the mem-

brane side up.

2. Place sensor on membrane

Place the sensor(s) with protection tube(s) on the

membrane but leave the wires hanging outside the

box.

To the extent possible, please place the sensor(s) on

the membrane.

3. Sensor between the two membranes

Place the second membrane inlay with membrane

side down onto the sensor(s).

Secure the wires in the plastic clips on the cardboard

part of the upper side of the inlay.

4. Close and ship

Close the lid and push the lid tabs into the slots in the

box sides.

Version: January 2020

/

Other documents