2. AFL
  3. INS-ACA056

AFL INS-ACA056 User manual

  • Hello! I'm your assistant. I've reviewed the Installation Instructions for the Longspan Tie INS-ACA056. This document describes step-by-step guide for installing the tie and mentions safety measures. I'm ready to answer any questions you may have about the installation process or the product itself.
  • What should I do before starting the installation?
    What should i do with the Tie Pad?
    How should I install the Longspan Tie?
1
Installation Instructions
INS-ACA056
Formed Wire
© 2013, AFL, all rights reserved. Revision 1, 9.7.2021
Specications are subject to change without notice.
AFLglobal.com
|
800.235.3423
continued
Installation Instructions
NOTE: READ AND UNDERSTAND INSTALLATION INSTRUCTIONS BEFORE INSTALL. ENSURE YOU HAVE THE CORRECT
PREFORMED PRODUCT BEFORE INSTALL IS STARTED
Longspan Tie with Pad
Cold Application
1. Apply the Tie Pad to the conductor so the conductor does not
come into direct contact with the insulators. Keep the Tie Pad
slit facing upward.
2. Bend the Longspan Tie open a little more to make it easier to
fall into place and set itself.
Tie Pad
Elastomeric Center
Section
Color Code
3. Install the Longspan Tie over the center of the insulator so that
both legs are parallel to the conductor.
Insulator Identication Mark
"C" Neck—Black
"F" Neck—Yellow
"J" Neck—Green
4. Rotate the Longspan Tie counter-clock-wise. Ensure both legs
go under the conductor. Rotate the Longspan Tie until the legs
seat themselves.
© 2013, AFL, all rights reserved. Revision 1, 9.7.2021
Specications are subject to change without notice.
AFLglobal.com
|
800.235.3423 2
Installation Instructions
INS-ACA056
Formed Wire
Longspan Tie with Pad
5. Bend one leg of the Longspan Tie around the neck of the insulator.
Ensure the Tie is rmly seated under the insulator ear.
6. Continue wrapping the Longspan Tie legs until it is completely
wrapped.
7. Snap the end of each leg into place. Ensure the Longspan Tie
end fully snaps into place. This may require more pressure than
the pressure to wrap.
Safety
1. Longspan Ties are precision devices. They should be stored in
covered cartons and handled carefully.
2. This application procedure is NOT intended to supersede any
company construction or safety standards. This procedure is
offered only to illustrate safe application for the individual.
Failure to follow these procedures and restrictions may result in
personal injury.
3. For proper performance and personal safety ensure the proper
size Longspan Tie has been selected before installation.
/