I N S T R U C T I O N S
A ssemble p ol e .
1
Assem b le the Stand
Inse r t b ot t om and l o ck c onne c t or b y r ot a ting
handle cl o c k wise and pushing handle d o wn.
3
Inse r t t op b y sliding ta p e r ed end i n t o t op of p ole
and push flush.
4
F ind b ot t om and t op of graphic and pole.
2
V e r ify the g r aphic is not t wis t ed and th a t the g r aphic
c o v ers the c o r ner s .
Important :
N o t e : T he di r e c tions a r e the same f or each sha p e .
T op
B ot t om
(without c onne c t or)
(with c onne c t or)
T op
(with light hole)
Bottom
(without hole)
5
Adjust lean to make vertical.
-After prolonged periods of storage, the graphic may have wrinkles.
To eliminate the wrinkles leave the stand set-up for several hours or use a steamer.*
*A Micro Steamer option is available.
Helpful Tip: It’s easier to make the top connection
if the stand is held at waist level rather then if your
hands are held up over your head.
www.AdvatumDisplays.com
I N S T R U C T I O N S
Connect the Shelf
Connect the Stand O f f G r a phic
Attach shelf. (Tube with hole)
-The higher the shelf is positioned, the more likely it is to
touch the side of the graphic.
- T o a v oid damaging the ac r ylic shelf when disassembling
the stan d , b e su r e t o detach the shelf f r om the utili t y bar
b e f o r e r em o ving the utili t y bar f r om the stan d .
A ttach stand off g r aphic t o utili t y bar with V elc r o st r i p .
2
Attach support base.* (Tube without hole)
*Left Slope, Right Slope, and Fountain only
1 2
A ttach utili t y bar t o main p ol e .*
1
- Utility bar can b e pla c ed a n y whe r e
b e t w een 20 ” h and 46 ” h.
- T he l o w er the stand off g r aphic is p ositione d ,
the closer it
will b e t o the main g r aphi c .
- Guarantee excludes scratching or breaking of acrylic shelf.
Shelf Placement *
Left Slope 30”h to 46”h
Right Slope 30”h to 46”h
Fountain 30”h to 46”h
Bow 36”h (not adjustable)
*Shelf and base can connect from either side
- To improve the strength of the shelf and base tube
tighten the connector clamps.
Weight Limit
-12 lbs. max per shelf
-20 lbs. combined total
for multiple shelves
*Can connect from either side
/
