2. AFINIBOT
  3. A9

AFINIBOT A9 Assembly Instructions Manual

  • Hello! I am an AI chatbot trained to assist you with the AFINIBOT A9 Assembly Instructions Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Equipment assembly instructions
I. Open the packaging, accordance packing list, check the parts are intact.
II. Z axis assembly
1. Assemble Z Axis Frame
Two of Each M5 * 8 screws
and M5 T-nuts
2. Assembled Z-axis fixed block
3. Install the Z-axis limit switch
4. Install Z-axis motor
End with Inside Screw upside
Holding two planes on the same plane
Four of each M4 * 8 screw
and M4 T-nut
Two of each M4 * 10 screw
and M4 T-nut
One M5 * 12
screw
Two M3 * 16 screws
Two of each M4 * 14 flat head
screws and T-nuts
III. Install X axis
First locking M4 * 14
Then lock M3 * 16
Prevent the motor end
of the Z-axis tilt
Counterclockwise
rotation Z-axis
screw
Pressing Teflon pipe joint,
locking Teflon tube
I. Install handle
IV. Circuit wiring
1. Motherboard wiring diagram
2. The physical wiring diagram
E Extruder Motor
X-Axis Motor
X-Axis Limit Switch
Y-Axis Motor
Y-Axis Limit Switch
Z-Axis Limit Switch
Z-Axis Motor
3. Motherboard physical wiring diagram
V. Install base
Nine M3 chassis screws
VI. Installation Completes
/