Whirlpool AKP 766 IX Owner's manual

Type
Owner's manual

This manual is also suitable for

AKP 766 PRODUCT DESCRIPTION SHEET
PL CZ SK HU BU RO RU
5019 310 53081
First...Last:
Runner positions
1.
Control panel
2.
Cooling fan (not visible)
3.
Upper heating element
4.
Grill element (can be lowered)
5.
Oven light
6.
Fan
7.
Lower heating element (not visible)
8.
Oven door hinges
9.
Oven door
1.
Programmer
2.
Thermostat control knob
3.
Functions selector knob
4.
Thermostat red indicator light
5.
Spark ignition button
Important:
An optional kit consisting of an oven
door glass and of relevant mounting components, is
available by the After-Sales Service. The use of the
kit reduces the temperature of the outer oven surface
and is strongly recommended if there are kids in the
house.
Code N°: 4819 310 39186.
OVEN
CONTROL PANEL
Accessories:
Grid
Baking tray
Drip tray
Last
First
5019 310 53081
GB
0
Off
Oven light
STATIC FUNCTION
Use when all the food is on the same runner level.
-
Pre-heat the oven to the required cooking
temperature and place the food inside as soon as the
red thermostat indicator light switches off.
-
Ideally, the shelf should be on the second runner
level when using the static function.
STATIC FUNCTION + FAN
Use this function when cooking on two different levels.
-
Oven pre-heating is not necessary (except for pizzas
and focaccia).
-
Switch the position of the dishes in the oven 10
minutes before the end of cooking time.
-
Remove the cooked dish and, if necessary, continue
cooking the other one for as long as required.
GRILL FUNCTION
Use the grill function to cook small pieces of meat
(steaks, sausages) and for making toasts.
-
The oven door must be closed during the cooking
cycle.
-
Pre-heat the grill for about 5 minutes.
-
Arrange the meat on the grid with the drip tray
underneath. Pour water in the drip tray to cover the
bottom to reduce smoke and fat spatters.
-
Turn over the meat about half-way through cooking
time.
GRILL FUNCTION + FAN
Ideal for large joints, pork, chicken and roast beef.
-
The oven door must be closed during the cooking
cycle.
-
Place the meat on the grid with the drip tray
underneath. Pour water in the drip tray to cover the
bottom to reduce smoke and fat spatters.
-
Turn over the meat about half-way through cooking
time.
DEFROST FUNCTION
Ideal for thawing frozen food to room temperature.
-
The food should be inserted in the oven in its
wrapping to prevent it from drying out.
Turn the selector knob to the required symbol.
The oven light switches on.
Turn the thermostat knob clockwise to the required
temperature.
The red thermostat indicator light switches on.
When the required temperature is reached, the red
thermostat indicator light switches off.
End of the cooking cycle
Return the knobs to the OFF position (
0-
).
OVEN FUNCTIONS
SWITCHING THE OVEN ON
5019 310 53081
GB
I
mportant: the programmer symbols are given as an indication only;
for correct operation of the programmer, follow the instructions and
illustrations given on these pages.
CONTROL BUTTONS AND SYMBOLS
1. Button used to select minute minder with acoustic signal
2. Button used to set the cooking duration
3. Button used to set the end-of-cooking time
4. Button used to select manual operation
5. Button used to set or change data
6. Button used to set or change data
AUTO:
when permanently alight, indicates operation of the
oven in automatic mode.
AUTO:
will also blink to confirm end-of-cooking, prompt
further programming or indicate a wrong selection.
indicates that the oven is in operation and enabled in
manual mode.
indicates operation of the minute minder.
SETTING THE CLOCK, AND SELECTING MANUAL
OPERATION
When the appliance is installed new, or following a power
failure, digits
0:00
and the
AUTO
symbol will blink in the
display. All other functions remain inhibited.
Press and hold buttons
2
and
3
simultaneously, and set the
clock using buttons
5
and
6.
To operate the oven manually, press button
4
: the symbol
will be displayed.
USING THE MINUTE MINDER WITH ACOUSTIC SIGNAL
This function is independent of oven operation
Press button
1
: digits
0:00
are displayed
Press button
5
or
6
to display the desired cooking time.
Having released the buttons, or a few seconds afterwards, the
actual time and the symbol are displayed.
The acoustic signal warns that the set time has elapsed.
Press button
1
to silence the acoustic signal.
PROGRAMMING THE COOKING TIME
Press button
2
: digits
0:00
are displayed; set the desired
cooking time with buttons
5
and
6
. After a few seconds, the
actual time is displayed with
AUTO
and the symbol both
permanently alight.
Set the oven control knob to the temperature required:
the oven will come into operation immediately.
Once the cooking time has elapsed, an acoustic signal
indicates that the oven has switched off.
Return the oven control knob to position
0
, then press
button
4
to silence the acoustic signal.
Note: the time remaining until end-of-cooking can be checked
or altered at any moment by pressing button
2
.
The end-of-cooking time can also be displayed by pressing
button
3.
USING THE PROGRAMMER
5019 310 53081
GB
PROGRAMMING DURATION AND END OF COOKING TIME
Press button
2
: digits
0:00
are displayed; set the desired
cooking time with buttons
5
and
6
. After a few seconds,
the actual time is displayed with
AUTO
and the
symbol both permanently alight.
Press button
3
to set the end of cooking time, which is
selected using buttons
5
and
6
. The symbol will now
go out, and reappear again when the oven comes into
operation automatically at the start of the programmed
duration.
Set the oven control knobs to the temperature and
functions required.
Once the cooking time has elapsed, an acoustic signal
indicates that the oven has switched off.
Return the oven control knob to position
0
, then press
button
4
to silence the acoustic signal.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Whirlpool AKP 766 IX Owner's manual

Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI