Brodit 835012 Datasheet

Category
Holders
Type
Datasheet
27 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 835012
835012 ProClip
Console mount, Left
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288350127
Item no 835012 fits:
Porsche Macan 15 (For all countries)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read the instructions and look at the pictures before installing the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel of the adhesive tape
cover on the ProClip. Press the thin end of the enclosed gap opener into the gap between the console edge and
the center console panel. Then press the angled edge on the right side of the ProClip into the gap in front of the
gap opener. Remove the gap opener.
2. Using your fingers, pull out the rubber edge next to the left part of the ProClip slightly, to widen the gap. At the
same time, press down on top of the ProClip with your other so the ProClip flexes downward and the angled edge
hooks into the gap.
3. and 4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 835012 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI