King Canada KKC-60 User manual

KNIFE JIG ALIGNMENT

KIT FOR JOINTERS

INSTRUCTION MANUAL

MODEL: KKC-60

KNIFE JIG ALIGNMENT

KIT FOR JOINTERS

With the traditional method, the jointer knife is adjusted the same way as the

other knife jigs, using a standard knife adjusting gauge the knives can be

adjusted to the height required and be even with the other cutterhead knives. This

alignment jig has been designed to help users set their Jointer knives quickly and

accurately in order to obtain precision cuts.

INSTRUCTIONS:

1) Position the jig flat on top of the rear table surface with the magnetic points

facing downwards. The four magnetic points (A, B, C and D. See illustration

below) will become the alignment level of the knife. The magnetic points of E

and F will keep the knife at the same height of A, B, C and D as illustrated

below. Lock the knife gib screw in order to hold in position, the height of the

knife tip will be equal to the height of the rear table surface.

2) Repeat step #1 for all other cutterhead knives.

Capacity: 0” to 12’ (0 to 318mm)

Ex. 4” (102mm)

6” (152mm)

8” (204mm)

10” (255mm)

12” (305mm)