Jam clear instruction
No-marring tip
Wrench
Pull out the No-marring Tip, Loose the
two bolts with the wrench on tool.
Take off the outer panel, contact safety
pole and the middle panel , keep these
parts for reassembly.
Remove the jammed brad nail, place back
the middle panel, contacted safety pole.
Middle panel
Contact
safety
pole
Place back the outer panel, two spring
washers and bolts and tighten the bolts by
hand first.
Spring washer
Two bolts
Tighten the two bolts with wrench,
assembly the No-marring tip.
Check there is no gap between
middle panel and magazine, the
gap will cause to double brad nail.
  • Page 1 1
  • Page 2 2

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI