5925 Heisley Road • Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
OPERATING and MAINTENANCE INSTRUCTIONS
Model: 120 and 121 Series Proofi ng Cabinets
Proofi ng
Cabinet
FL-0300-3
Rev. 7 (3/10) Page 2 of 4
Allow cabinet to cool.1.
Remove Hot unit from cabinet.2.
Do NOT use abrasives or harsh 3.
chemicals.
HOW TO CLEAN THE CABINET:
WARNING
BEFORE cleaning
the cabinet:
HOW TO START UNIT:
Turn the POWER switch on. The 1. Yellow light will
come on.
Turn thermostat to #10.2.
Preheat cabinet for 30 minutes.3.
Put fresh or fully thawed dough into cabinet.4.
NOTE: The cabinet temperature will drop temperature
inside cabinet if cold dough is added.
Do NOT put frozen dough into cabinet
Turn thermostat to #9 and close door.5.
NOTE: No. 9 setting will give you a temperature of
95°F, and 90-95% humidity. Experiment with
different settings to get the exact temperature
and humidity you need. The thermometer shows
the temperature inside.
NOTE: Check water level in water pan if you are
proofi ng longer than 90 minutes. Fill with hot
water.
MAINTENANCE
HOT UNIT REMOVAL INSTRUCTIONS:
Unplug cord set from wall outlet and from back of 1.
cabinet.
Remove one screw from back of cabinet that is 2.
above receptacle.
Slide the whole unit out the front of the cabinet.3.
HOW TO TURN UNIT OFF:
Turn thermostat off. The red light will go out.1.
Turn the POWER switch off. The 2. Yellow light will
go out.
Cleaning hints:
Wipe up spills as soon as possible.1.
Clean cabinet regularly to avoid heavy dirt build-up.2.
Make a test spot with cleaner.3.
Follow manufacturer’s directions on cleaner.4.
Do not mix cleaners.5.
Avoid drips and splashes.6.
HOW TO CLEAN THE UNIT:
Soil Cleaner Method
DOOR
(Polycarbonate)
DIRT Mild *detergent and water.
1. Wipe with soft, damp cloth.
2. Rinse well.
GREASE and OIL Weak, alcohol-type cleaner.
1. Wipe with soft, damp cloth.
2. Rinse well.
CABINET
(Aluminum)
Inside
and
Outside
DIRT Mild *detergent and hot
water, or mild abrasive
cleaner.
1. Use soft, damp cloth.
2. Rinse with hot water.
3. Wipe dry
Steam (no strong alkaline
additive)
1. Rinse after steam cleaning.
2. Wipe dry.
FINGERPRINTS,
GREASE and OIL
Chemical oven cleaner for
aluminum
Follow oven cleaner manufacturer’s
directions.
Mild abrasive cleaner; oily
or waxy cleaner.
Apply with soft, clean cloth.
WATER SPOTS Mild abrasive cleaner 1. Apply with damp cloth.
2. Rinse and dry.
*Mild detergents include soaps and non-abrasive cleaners.