~
To protect the refrigerator from
possible damage, take care that it
always remains in an upright position.
Any time it is moved or installed, always
let it stand for 30 to 60 minutes before
plugging it in. This allows the coolant
and lubricant to settle down, which is
essential for proper operation.
~
Before connecting the appliance,
make sure that the connection data on
the data plate (fuse rating, voltage and
frequency) matches the power supply.
This data must correspond in order to
avoid damage to the appliance. If in
doubt, consult a qualified electrician.
~
The electrical safety of this
appliance can only be ensured if it has
been properly grounded in compliance
with the applicable safety regulations. It
is most important that this basic safety
requirement is observed. If there is any
doubt contact a qualified electrician.
~
The electrical safety of this
appliance can only be ensured if it has
been properly grounded in compliance
with the applicable safety regulations. It
is most important that this basic safety
requirement is observed. If there is any
doubt about the grounding of your
household wiring, have it inspected by
a qualified electrician.
~
Do not connect the appliance to the
electrical supply with a power bar or
extension cord. These are a fire hazard
and do not guarantee the required
safety of the appliance.
~
Do not use the appliance in areas
where there may be moisture or
splashing water (e.g. garages, laundry
rooms, etc.)
Moisture can reach the electrical
components and cause a short circuit.
~
This appliance is not to be used in
mobile locations such as ships.
~
A damaged appliance can be
dangerous. Before installing the
appliance, check for visible damage.
Do not operate a damaged appliance.
~
To ensure safe operation, use the
appliance only when it is fully installed.
~
Ensure the appliance is
disconnected from the power supply
during installation, maintenance and
repair work or work on the water
supply. The appliance is only
completely disconnected from the
electrical supply when:
– the respective circuit breaker is
tripped,
– the respective fuse is removed, or
– the power cord is unplugged.
Pull on the plug and not on the cord
when removing it from the outlet.
~
Improper installation, repair and
maintenance work or work on the water
supply can be dangerous for the user
of the appliance. Installation, repair and
maintenance work or repairs on the ice
cube maker should only be performed
by a Miele authorized technician.
~
Repairs not performed by a Miele
authorized service technician will void
the warranty.
IMPORTANT SAFETY INSTRUCTIONS
7