Midmark 230 Universal Procedures Chair Installation guide

Brand: Midmark

Model: 230 Universal Procedures Chair

Type: Installation guide

1© Midmark Corporation 2006

MA732200i

003-1611-00 Rev. AA1 9/12/17

Components:

Support Boards:

Back Section ................ 1

Seat Section ................. 1

Upholstery Sections:

Back / Seat .................. 1

Head ............................. 1

Foot .............................. 1

Leg ............................... 1

Flat & Narrow Upholstery Kit for

230 /75e

[002-0950-xxx, 002-0951-xxx, 002-10135-xxx,

002-10136-xxx]

Step 1: Remove standard back

& seat support boards.

Step 3: Install narrow back

& seat support boards.

NOTE

The foot and leg sections of the flat & narrow

upholstery set are the same size as the standard

upholstery. These sections are provided for new

installations and color changes, it is not necessary

to replace them.

Step 4: Install paper roll holder on

narrow back support board.

Step 2: Remove paper roll holder from

standard back support board.

ATTENTION! Applies to 230 Models before serial number V1831829

The labels on the standard back support board are

essential for model identification and regulatory

compliance.

Retain the standard support board with labels intact.

Style A

Lock Levers

Mounting Studs

To install seat / back section upholstery...

A. Position front of seat section against mounting board.

B. Lay upholstery flat, then press down firmly.

To install headrest upholstery...

A. Insert mounting studs into holes in pivot mount.

B. Push three lock levers inward to lock in place.

Midmark Corporation

60 Vista Drive

Versailles, OH 45380-0286

Phone: 937-526-3662

Fax: 937-526-5542

midmark.com

To install foot & leg section upholstery...

Align velcro strips - press down firmly.

Midmark 230 Universal Procedures Chair Installation guide

Midmark 230 Universal Procedures Chair Installation guide

Midmark 230 Universal Procedures Chair Installation guide

Related papers

Other documents