Netgear GS308P-100PES Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Netgear GS308P-100PES Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Getting started with the
NETGEAR
®
GS308P 8-Port PoE Gigabit
Ethernet Unmanaged Switch
Frequently Asked Questions
1. What are the key features of the GS308P?
•8copper10/100/1000MbpsRJ-45Ethernetports
•Ports1-4arePoE802.3afcapableofprovidingupto15.4Wper
port,andnottoexceed53WtotalacrossallactivePoEports
•LEDsforPower/PoEMax/PortSpeed
•AutoMDI/MDI-X
•802.3xFlowControl
•802.1pQoSandDSCP
•802.3azEnergyEcientEthernet(EEE)compliance
•Wall-mountable
2. What is 802.3az Energy Ecient Ethernet
(EEE) compliance?
802.3azisanIEEEstandard,whichallowsforlesspowerconsumption
duringperiodsoflowdataactivity.
3. Does the GS308P support jumbo frames?
Yes,itsupportsjumboframesupto9720bytes.
4. How many MAC address table entries does the
GS308P support?
4K.
5. What is Power over Ethernet (PoE) and how do I use it?
PoweroverEthernetusesEthernetcablestosupplypowertoother
PoEcapabledevicesonthenetwork,suchasWirelessAccessPoints,
IPcameras,VOIPphones,andotherswitches,etc.TheGS308Pisa
PowerSourcingEquipment(PSE)deviceandiscompliantwiththeIEEE
802.3afspecication.ItcansupplypowertoanyPoweredDevice(PD)
whichsupportsthissamestandard.Thisfeatureallowstheuserto
powerthesedeviceswithouttheneedforaseparatepowersupply
ortheneedforanelectricaloutletnearthePDdevice.
6. What is the maximum PoE power that the GS308P
can supply?
ThemaximumpowerthattheGS308PcandelivertoallPDsis53
Wattstotal,withamaximumpowertoeachportof15.4W.Supplied
powerisprioritizedaccordingtotheportnumber(i.e.Port1,followed
byPort2,andsoon)uptothetotalpowerbudgetofthedevice
(53W).Ifthepowerrequirementsfortheattacheddevicesexceeds
thetotalpowerbudget,thedeviceonthehighestportnumber(Port
4)withbedisabledtoensurethatthedevicesconnectedtothehigher
priorityports(Ports1-3)aresupportedrst.Itisimportanttonote
thatjustbecauseadeviceislistedasan802.3afPoEDevicedoesnot
necessarilymeanthatitrequiresthemaximumpower(15.4W)limitof
thespecication.Manydevicesrequireless,allowingallfourPoEports
tobeactivesimultaneously.
7. What is the PoE Max LED for?
ThePoEMaxLEDindicateshowmuchpowerisavailableforyourPD.
• “O”indicatesthereisatleast7WattsofPoEpoweravailable.
• “Solid Yellow”indicateslessthan7WattsPoEpowerisavailable.
• “Blinking Yellow”indicatesthePoEMaxLEDwasactiveinthe
previous2minutes.
8. What type of AC/DC power adapter does the GS308P use?
TheGS308PPoEswitchcomeswithanexternal48V/1.25A
AC/DCpoweradapter.
TheGS308Pisan8-portGigabitEthernetUnmanagedSwitchwith4portsPoE-capableand
inametalcase.AsanUnmanagedSwitch,itisplug-and-play,sothatonceitispoweredon
andcabledcorrectly,itwillimmediatelywork(i.e.itisnotcongurable).
NETGEAR and the NETGEAR logo are trademarks and/or registered trademarks of NETGEAR, Inc.and/or its subsidiaries in the United States and/or other countries. Other brand names mentioned herein are for identification
purposes only and may be trademarks of their respective holder(s). Information is subject to change without notice. © 2015 NETGEAR, Inc. All rights reserved.
/