Roland V-Drums Portable TD-4KP User guide

TD-4KP

Setup Guide for Lefty

Completed Setup

fig.0.eps

1 Open the stand

fig.1-e.eps

1. Loosen the knob.

2. Bend the stand to

the other side.

3. Close to less than 90 degrees.

Front

2 Attach the kick pad holder

upside down

fig.2-e.eps

1. Loosen the knob for the Pipe Holder (B) on the left side

(kick pad side), and then pull up the Pipe (A).

2. Use the drum key to loosen the bolt for the Pipe Holder

(B), and then remove the Pipe Holder (B).

3. Remove the Kick Pad Holder (C) once and attach it upside

down again.

4. Attach the Pipe Holder (B).

5. Attach the Pipe (A).

Pipe Holder (B)

Pipe (A)

Kick Pad Holder (C)

3 Assemble the drum set

Assemble the drum set according to the procedure after step

“3 Extend the pipes” in the Setup Guide 1 attached to TD-4KP.

* In step “9 Attach the kick pad,” attach the pedal plate for lefty in your

hand instead of the pedal plate for righty attached to your TD-4KP.

fig.3-e.eps

for lefty for righty

This manual is also suitable for

Download PDF