AEO Solar Water Pump KIT: 12V-24V DC Brushless Submersible 196GpH Water Pump User manual

Brand
AEO
Model
Solar Water Pump KIT: 12V-24V DC Brushless Submersible 196GpH Water Pump
Type
User manual

AEO Solar Water Pump KIT: 12V-24V DC Brushless Submersible 196GpH Water Pump

This pump is ideal for a wide range of applications, including:

  • Fountains: Create a beautiful water feature in your garden or pond.
  • Waterfalls: Add a touch of tranquility to your backyard with a cascading waterfall.
  • Aquariums: Keep your fish and aquatic plants healthy with a constant supply of fresh, oxygenated water.
  • Hydroponics: Grow plants without soil using this pump to circulate nutrient-rich water.
  • Irrigation: Water your plants evenly and efficiently with this pump's adjustable flow rate.

AEO Solar Water Pump KIT: 12V-24V DC Brushless Submersible 196GpH Water Pump

This pump is ideal for a wide range of applications, including:

  • Fountains: Create a beautiful water feature in your garden or pond.
  • Waterfalls: Add a touch of tranquility to your backyard with a cascading waterfall.
  • Aquariums: Keep your fish and aquatic plants healthy with a constant supply of fresh, oxygenated water.
  • Hydroponics: Grow plants without soil using this pump to circulate nutrient-rich water.
  • Irrigation: Water your plants evenly and efficiently with this pump's adjustable flow rate.
AEO-WP40SP10-KIT
10W SOLAR PANEL & DC WATER PUMP KIT
USER MANUAL
Place the Water Pump under water BEFORE connecting to a power source.
The water pump may become damaged if it is not under water before powering it on.
The plugs on the power cable connected to the Solar Panel (1) and power cable connected to the Water
Pump (2) must match in polarity (+ -). Connect the two plugs by matching the flat sides. (See fig. 2.3 in
Section 2.)
This is a DC (Direct Current) water pump. DO NOT connect to any AC power.
The performance of the pump depends on sunlight intensity and the angle at which sunlight strikes the
solar panel surface. For safety purposes, the Solar Panel is at recommended 18V, because a 24V solar
panel actual output will exceeds its nominal voltage when sunlight at highest intensity.
Please carefully read this user manual before installing the pump.
Section 1: INCLUDED
Section 2: CAUTIONS
1) Make sure the water pump is fully submerged underwater while it is operating.
2) Do not connect the pump to any AC power supply; it is designed ONLY for DC power. The Solar Panel included is 18V
because the output is usually greater.
3) The polarity of the power cable plug on the Water Pump (2) must match the plug
on the Solar Panel (1) as shown in the figure to the right. Connect the two plugs by
matching the flat sides; do not force them together.
4) Any alteration of the product itself or changing of the components voids
warranty.
5) Operate the pump in water only (under 104°F), and keep it away from
flammable liquids.
6) Do not let the pump run dry; it does not have dry-run protection.
Section 3: ASSEMBLY
*Unpack all components carefully.
1. [Setup Water Pump]
a. Connect the nozzles tubes (adjust the height by the number of tubes) to the water pump outlet to produce a
(1)
Solar
P
anel
(2) Water Pump
(3) Ground Spike
(4) Nozzle Kit
fountain effect above the surface of the water. Use a taller base such as bricks or marble slabs if the cylinder is not
high enough.
b. Connect one of the fountain heads on top of cylinder tubes for different water patterns.
c. Place the water pump under the water (fish tank, small pond, etc.), but on top of a base such as a brick or marble
slab to prevent dirt, mud, or sand from getting into the filter. For deep water, the AEO Floating Pad is
recommended and can be found on Amazon.com by searching for “AEO Floating Pad”.
2. [Place the Solar Panel] on the garden lawn or soft ground by jabbing the spike into the ground. Adjust the panel to
face it towards the direction of the sun where the sunlight is strongest during the day. Keep the Solar Panel clear of
shade and dirt.
3. [Connect the Water Pump to Solar Panel] by connecting the plugs on the power cable connected to the Solar Panel
(1) and power cable connected to the Water Pump (2) must match in polarity (+ -). Connect the two plugs by
matching the flat sides. See Section 2: CAUTIONS.
Section 4: CLEANING AND MAINTENANCE
Periodically clean the water pump to prevent blockage.
! Caution ! Handle with care to prevent the impeller from falling out and breaking while detaching the unit. Disconnect
Water Pump from Power before cleaning.
1) Pull the filter housing apart from the pump while squeezing the sides.
2) Press on the bottom board while sliding it in the direction of the arrow.
3) Turn the impeller cover counter-clockwise and then carefully pull it out. Impeller maybe attached to the cover or
stay inside the pump. Be aware of the white washers may fall out.
4) Separate the impeller from the water pump or detach it from the impeller cover.
5) Wash every part including the inside of motor chamber and clean out the debris.
6) Assemble the pump in reverse sequence then put water pump back under water, connect power to start running
7) Keep the surface of the solar module clean and wipe it with a soft and moist cloth when necessary.
Section 5: TROUBLE-SHOOTING
*Pump stopped running?
1) Check power source: make sure the Solar Panel is fully exposed to sunlight and is not covered in shade or dirt.
2) Check for blockage: clean the pump as described in Section 4: CLEANING AND MAINTENANCE.
3) Check the water: make sure the water pump is fully submerged in water.
*Pump is running, but there’s no water going through?
1) Check for blockage: clean the nozzle tubes, water pump outlet, and filter to remove any debris
Section 6: TECHNICAL DATA AND PUMP CURVE
Peak Power of Solar Panel
W
Solar Panel
Nominal
V
oltage
18
V
Maxim
um
P
ump
Head (Hmax)
1.7
M |
5.6
FT
MaximumFlow
Rate (Qmax)
610
LpH |
161
GpH
Cable
L
ength
5
M
|
16.
4
FT
If the product is defective or damaged upon
delivery, please contact our customer service by
email sup[email protected]
or call 909-698-8199 for help. Thank you!
  • Page 1 1
  • Page 2 2

AEO Solar Water Pump KIT: 12V-24V DC Brushless Submersible 196GpH Water Pump User manual

Brand
AEO
Model
Solar Water Pump KIT: 12V-24V DC Brushless Submersible 196GpH Water Pump
Type
User manual

AEO Solar Water Pump KIT: 12V-24V DC Brushless Submersible 196GpH Water Pump

This pump is ideal for a wide range of applications, including:

  • Fountains: Create a beautiful water feature in your garden or pond.
  • Waterfalls: Add a touch of tranquility to your backyard with a cascading waterfall.
  • Aquariums: Keep your fish and aquatic plants healthy with a constant supply of fresh, oxygenated water.
  • Hydroponics: Grow plants without soil using this pump to circulate nutrient-rich water.
  • Irrigation: Water your plants evenly and efficiently with this pump's adjustable flow rate.
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents