Page is loading ...
RF + WiFi SPI Controller
12VDC
Power Supply
Constant Voltage
Size
Picture Function introduction
Waterproof grade: IP20 Radio Frequency : 868mhz
RF
remote
1. Pair RF Receiver with RF remote:
1.1. Connect and wire up the RF receiver correctly, power on.
1.2. Turn on the remote, click the “RF Code Key” button on receiver, then touch color wheel on remote, the
connected led light on receiver flickers twice, means well paired.
Note: one receiver can be paired with max 8 remote controls.one remote control can pair with numberless
receivers.
2. Delete the pairing:
2.1. Wire up the RF receiver correctly, power on
2.2. Hold the “ RF Code Key” button on receiver over 3 seconds until the connected led light on receiver flickers
twice, means well deleted.
With digital IC LED lights
RF code key:pair with the RF sender
12VDC
Power supply
Constant voltage
Wiring diagram
09.SPIRW.04466
Input
Voltage Remarks
Input
Current
12VDC RF Wireless
SPI Signal
0.2A max
Output
145.00 mm
46.50 mm16.00 mm
RF Co de Key
V+
V-
INP UT
V+
V-
OUT PU T
RF SPI C on troller
CLK
DATA
-
CLK
DATA
+
Using instruction with IOS or android system
Please check ‘Easylighting’ application manual. WiFi password:0123456789
Cellphone
Res et
Swi tch
Master/Slave jumper
Reset switch
RF Co de Key
V+
V-
INPUT
V+
V-
OUTPU T
RF SPI Cont roller
CLK
DATA
Res et
Swi tch
/
