Memory Module Specification
DESCRIPTION:
This document describes ValueRAM's 128M x 72-bit 1GB (1024MB) CL3 DDR400 SDRAM
(Synchronous DRAM) ECC memory module. The components on this module include eigh-
teen 64M x 8-bit (16M x 8-bit x 4 Bank ) DDR400 SDRAM in TSOP packages. This 184-pin
DIMM uses gold contact fingers and requires +2.6V. The electrical and mechanical specifi-
cations are as follows:
FEATURES:
Clock Cycle Time (tCK) 5ns (min.) / 10ns (max.)
Row Cycle Time (tRC) 55ns (min.)
Refresh Row Cycle Time (tRFC) 70ns (min.)
Row Active Time (tRAS) 40ns (min.) / 70,000ns (max.)
Single Power Supply of +2.6V (+/- .1V)
Power (IDD0) 3.950 W (operating)
UL Rating 94 V - 0
Document No. VALUERAM0328-001.A00
02/13/04
Figure 1: KVR400X72C3A/1G 184-Pin DDR SDRAM Module
KVR400X72C3A/1G
1GB 128 x 64-Bit DDR400
CL3 184-Pin ECC DIMM
1.250
0.700
0.393
0.000
0.000
2.886
5.250
0.050
0.0078 ±0.006
(0.20 ±0.15)
(1.270)
0.100
(2.50 )
0.250
(6.350)
0.157
(4.00)
0.071
(1.80)
0.039 ± 0.002
(1.000 ± 0.050)
(3.80)
2.175
(6.62)
0.26
0.1496
(3.00)
0.118
(2.00)
0.0787
(4.00)
0.1575
(31.75)
(17.80)
(10.00)
(00.00)
(73.30)
(133.35)
Units : Inches (Millimeters)
1
(00.00)
Note: The module defined in this data sheet is one of several configurations available under this part number. While
all configurations are compatible, the DRAM combination and/or the module height may vary from what is described
here. However, in no configuration will the module height exceed 1.250" (31.75mm).