Memory Module Specification
DESCRIPTION:
This document describes ValueRAM's 128M x 72-bit 1GB (1024MB) DDR400 CL3
SDRAM (Synchronous DRAM) "dual rank" Registered ECC memory module. The compo-
nents on this module include eighteen 64M x 8-bit (16M x 8-Bit x 4 Bank) DDR400 SDRAM
in TSOP packages. This 184-pin DIMM uses gold contact fingers and requires +2.6V. The
electrical and mechanical specifications are as follows:
FEATURES:
Clock Cycle Time (tCK) 5ns (min.) / 10ns (max.)
Row Cycle Time (tRC) 55ns (min.)
Refresh Row Cycle Time (tRFC) 70ns (min.)
Row Active Time (tRAS) 40ns (min.) / 70,000ns (max.)
Single Power Supply of +2.6V (+/- .1V)
Power (IDD0) 6.120 W (operating)
UL Rating 94 V - 0
Part No. VALUERAM0438-001.A00
06/10/05
Figure 1: KVR400D8R3A/1G 184-Pin DIMM
KVR400DR3A/1G
1GB 128M x 72-Bit DDR400
CL3 Registered 184-Pin ECC DIMM
Note: The module defined in this data sheet is one of several configurations available under this part number. While
all configurations are compatible, the DRAM combination and/or the module height may vary from what is described
here. However, in no configuration will the module height exceed 1.200" (30.48mm).
1.200
0.700
0.393
0.000
0.000
2.886
5.250
0.050
0.0078 ±0.006
(0.20 ±0.15)
(1.270)
0.100
(2.50 )
0.250
(6.350)
0.157
(4.00)
0.071
(1.80)
0.039 ± 0.002
(1.000 ± 0.050)
(3.80)
2.175
(6.62)
0.26
0.1496
(3.00)
0.118
(2.00)
0.0787
(4.00)
0.1575
(30.48)
(17.80)
(10.00)
(00.00)
(73.30)
(133.35)
Units : Inches (Millimeters)
1
(00.00)