Strong™ Cooling Solutions

Strong Fan Bracket with Cool Components Fans

Overview

The Strong™ SR-FANBRACKET-2, SR-FANBRACKET-4, and the SR-FAN-2 are top-quality, DC (low voltage) fans with

an exclusive levitation bearing system for quiet and long lasting operation without taking up any rack space. Each fan is

designed for simple installation with the included hardware for Strong Racks. Control the voltage supplied to the fans to

adjust speed and therefore the noise. If more automated is desired, add the TC-ALTv2, or TC-ASC (both sold separately)

for thermostat control.

Included Accessories

Installation

• Loosely thread two nuts onto the rear pre-installed

mounting bolts. This will hold the cooling unit stable

while threading the other nuts.

Note: For the SR-FAN-2, from the top of the rack,

thread 4 bolts, nuts and washers per fan, and

tighten.

• On the top, inside of the rack, slide the Strong

cooling unit onto the pre-installed mounting bolts.

• Thread the included nuts onto the rack’s pre-

and effectiveness. Typically the power supply will

be set between 5 and 9V DC.

Rev: 140909-1400www.snapav.com Support: 866-838-5052

4.5” (120mm)

DC Fans

Short Y-cables

600mA

Power Supply

Strong Lifetime Limited Warranty

not apply to products that have been abused,

modied,ordisassembled.Productstoberepairedunderthiswarranty

must be returned to SnapAV or a designated service center with prior

noticationandanassignedreturnauthorizationnumber(RA).

Lifetime

Warranty (Bracket)

Cool Components Return Policy

from the date of purchase. This warranty excludes damage caused by

misuse or for applications other than the intended use of the products.

Warranty (Fan)