2. Putco
  3. 581002

Putco 581002, 581005, Element Sky View Installation guide

  • Hello! I've reviewed the installation instructions for the PUTCO Element Sky View Roof Panel. This document outlines the steps for replacing the hard top front section of your vehicle with the Element Sky View panel. It also details important care instructions to ensure the longevity of the product, such as cleaning with water and using touchless car washes. I'm ready to answer any questions you might have about the installation process or the roof panel itself.
  • What tool is needed for installation?
    How should I clean the clear roof panel?
    Can I take the Element Sky View roof panel through a car wash?
ELS — 12/8/22
Page 1 of 5
581002I
ELEMENT SKY VIEW
INSTALLATION INSTRUCTIONS
Congratulations on your purchase of a high quality PUTCO product. Should you need any application
or technical assistance, feel free to call us at: 1-800-247-3974
Monday-Friday 8:00 a.m. - 5:00 p.m. (Central Standard Time)
Contact your PUTCO dealer for other quality accessories.
Please
read
all
instructions
before
installation
and
to
check
to
see
that
all
parts
are
included.
Tools Needed:
− 6mm Hex Key
CONTENTS:
Description
Qty.
Element Sky View Roof Panel
1
M8 Bolt
4
M8 Washer
4
ELS — 12/8/22
Page 2 of 5
581002I
Installation Instructions:
1. Remove the front section of the factory hard top.
2. Place the Element Sky View panel on the top of the vehicle.
Installation Instructions Continued:
ELS — 12/8/22
Page 3 of 5
581002I
3. Close the two front clamps,. Then close the two front L-shaped clamps.
4. Close the rear two L-shaped clamps. (picture pointing to the rear clamps)
ELS — 12/8/22
Page 4 of 5
581002I
5. Loosely thread the four M8 bolts into the adapter plates.
6. Tighten the M8 bolts leaving a small gap between the Skyview hardware and the roll bar on the vehicle.
Do not overtighten.
ELS — 12/8/22
Page 5 of 5
581002I
Important note: Ensure that the factory
weather seal on Jeep is sticking out just like it
was from the factory freedom panels. Trying
to hide the seal by pushing it under the top
can compromise the weather-tightness of
your Jeep, potentially allowing moisture or
other elements to enter. To avoid this issue,
make sure the weather seal is properly
installed and sticking out as it should be.
Your new Element Sky View
Roof is now successfully
installed on your vehicle!
CARE INSTRUCTIONS
•
Do NOT use chemicals or abrasives on the clear roof panel.
•
Use only water and wipe GENTLY with a microfiber towel for cleaning. Applying too much pressure can
scratch the Element Sky View roof panel.
•
When taking the Element Sky View roof panel through a car wash, use only a TOUCHLESS car wash. The
brushes in a regular car wash can scratch the Element Sky View roof panel.
/