2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Fishbone Offroad
  7. FB21301

Fishbone Offroad FB21301 Installation guide

  • Hello, I'm your chat assistant. I've reviewed the installation instructions for the FISHBONE OFFROAD Universal In-Bed Tire Carrier. This document outlines the steps, tools required, and parts included to correctly install the tire carrier, including drilling and using the ratchet straps to secure the tire. I'm ready to answer any questions you have about the installation process or the device itself.
  • What tools are required for installation?
    What is included in the kit?
    How is the tire secured to the carrier?
FB21301
Universal Truck Bed
Universal In-Bed Tire Carrier
2130100
REQUIRED TOOLS
19MM Socket/Wrench
Drill
.5” Drill Bit
Drill Stop
Paint
Thread Locker
Marker
KIT CONTAINS
Carrier Bin
Ratchet Strap
Carriage Bolt
Hex Nut
Oversized Washer
QTY
1
2
4
4
4
FB21301
Universal Truck Bed
Universal In-Bed Tire Carrier
1 2130100
1) PLAN THE INSTALLATION
Place the carrier into the bed of your vehicle as
desired.
Take note and special care to ensure that during the
installation process, damage to vital components
won’t occur below the bed, and that the locations
underneath have enough clearance for the 4 bed
washers.
Place your tire onto the mount and ensure it will
rest without any complications.
With a marker, mark the bolt holes to help identify
the drill locations.
*Again, ensure that drilling below these points
won’t damage vital components*
2) DRILL
Begin drilling the bed with a drill stop starting with a
pilot and working your way up to a .5in bit.
3) INSTALL
Begin securing the carrier to the bed using the 4
carriage bolts, bed washers, and hex nuts with a
19mm socket/wrench.
Place your tire onto the carrier and secure it with
the included ratchet straps by hooking it into the
triangle shaped holes located on the front and back
of the bin.
/