2. Warrior Products
  3. 59012

Warrior Products 59012, 59000, 59011, 59025 Installation guide

  • Hello! I've examined the provided document which details the mounting dimensions for various Warrior Products Brush Guard models such as the 59000, 59010, 59011, 59012, 59015, 59016, and 59017. This includes physical dimensions and hole dimensions. The document specifies measurements A, B, C, D, E, height, and depth, as well as configurations for center hoops and mounting holes. I'm ready to answer your questions about these brush guards.
  • What does the document specify for the 59000 model?
    What does the document specify for 59012 and 59017 models?
    Are the Height and Depth measurements exact?
BRUSH GUARD A B C D E HEIGHT cDEPTH c1 2 3 4
59000 a49 43 20 26 2 9/16 14 1/4 2 9/16 44 1/2 N/A 21 1/2 1 1/16
59010 46 5/16 40 5/16 19 1/8 29 1/8 5 3/4 12 3/8 9 9/16 41 13/16 27 5/8 20 5/8 4
59011 47 3/8 41 3/8 19 1/8 29 1/8 3 1/8 12 3/8 7 42 7/8 27 5/8 20 5/8 1 3/8
59012 bN/A N/A 19 1/8 29 1/8 2 12 3/8 5 7/8 N/A 27 5/8 20 5/8 N/A
59015 46 5/16 40 5/16 19 1/8 29 1/8 5 3/4 18 1/8 11 3/4 41 13/16 27 5/8 20 5/8 4
59016 47 3/8 41 3/8 19 1/8 29 1/8 3 1/8 18 1/8 9 1/8 42 7/8 27 5/8 20 5/8 1 3/8
59017 bN/A N/A 19 1/8 29 1/8 2 18 1/8 8 N/A 27 5/8 20 5/8 N/A
a
b
c
Height is measured from the mouting surface to the highest point of the Brush Guard. Depth is measured from the rear mounting bracket to the front-most point of the Brush Guard. Due to manufacturing varitions, the Height
and Depth dimensions are approximate and may vary slightly.
STINGER
PRE-RUNNER
HOLE DIMENSIONS
BRUSH GUARD MOUNTING DIMENSIONS (INCHES)
59012 AND 59017 are Center Hoop only configurations with the two center mounting brackets positioned as shown in the figure below.
PHYSICAL DIMENSIONS
The center mounting brackets for the 59000 are identical to the outer mounting brackets shown below. There are a total of four (4) mounting holes instead of six (6). The tolerance on 59000 dimensions is ± 1/2".
***REFERENCE THE ILLUSTRATION ABOVE WITH THE CHART BELOW FOR PART-SPECIFIC DIMENSIONS***
FRONT OF VEHICLE
/