Rugged Ridge 11420.06 Installation guide

Brand
Rugged Ridge
Model
11420.06
Type
Installation guide

This manual is also suitable for

11420.05 - Billet Aluminum Climate Control Knob JK (Blue)
11420.06 - Billet Aluminum Climate Control Knob JK (Red)
Climate Control Knobs 2007- UP JK Wrangler (2dr-4dr) Installation Instructions
Contents:
(3) Billet Climate Control Knobs
Page 1 of 1
Step1: Before removing factory plastic control knobs mask off
sides of knobs and outer console edges as shown (pic.1).
use a minimum of three layers of masking tape to insure
that console surfaces are not damaged during removal
of knobs.
pic.1
Step2: Slide two flathead screwdrivers between plastic control
knob and masking tape as shown (pic.2). Pull both flathead
screwdrivers away from dash. If needed some leverage
can be applied to side of console. Make sure that masking
tape has been applied to edge of console before applying
leverage to avoid damage.
pic.2
Step3: Some plastic knobs may not work free using screwdrivers.
To remove these knobs place three layers of masking tape
onto plastic knob and work loose using pliers (pic.3). The
pliers should be used to help loosen plastic knob. Repeat
step #2 for final removal of knob.
Step4: With plastic knob removed orient new billet knob to keyed
shaft. Press completely into console and turn knob to insure
proper function of control switch (pic.4).
Step5: Repeat steps 1 - 4 for other two knobs being careful to not
damage console. Remove masking tape and check each knob
for proper function.
pic.3
pic.4
NOTICE : Read all installation instructions prior to installing billet knobs to avoid scratching
or damaging center console and original plastic knobs.
  • Page 1 1

Rugged Ridge 11420.06 Installation guide

Brand
Rugged Ridge
Model
11420.06
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents