SCE SCE-GA14X75 Installation Information

.750 ± 0.060 offset from inside

of door bend on hinge side only

Apply strip gasket tightly to the

inside of these (3) door bends

1. Thoroughly clean sealing surface of Stainless Steel or Powder Coated enclosure

with a 50/50 isopropyl (rubbing alcohol) water mixture, or similar cleaning

solvent and wipe dry.

2. Apply rm pressure to the entire bond line for adhesion. For full adhesion,

minimum dwell time of 72 hours at 65F or greater.

3. Apply the gasket to the top of the door rst (A) from corner to corner.

4. Apply the left (B) and right side (C) gasket tightly against the top gasket and to

the bottom of door as shown, locating the hinge side gasket.

5. Apply bottom gasket (D) tightly against right and left gasket.

Door interior view

(Gasket Application)

Door 3/4 view

strip-gasket-installation.pdf

Strip Gasket Installation Instructions

This manual is also suitable for

Download PDF