QMS CrownCopy Stand Install Manual

CrownCopy Stand
QMS
Brand
QMS
Model
CrownCopy Stand
Type
Install Manual

This manual is also suitable for

QMS CrownCopy
™
Stand Installation
®
Introduction
The copy stand is made of a strong, clear acrylic that allows you to
place the CrownCopy scanner above the QMS 2425/2425 TURBO
Print System.
Printer Front
Stackler
Copy Stand
CrownCopy
Scanner
Printer
Back
Slots that the
Copy Stand clips
into (upper-left
side of printer)
Installation
Installation
Use the following procedure to install the CrownCopy stand:
1 Unpack the copy stand.
▲ Caution:
Do not lean or place any object over 40 lbs (18.6 kg) on
the upper shelf of the stand.
2 Place the copy stand on top of the printer, ensuring that it
clips down into the slots located on the upper-left side of the
printer.
3 Place the scanner on the stand with its interface ports facing
the back of the printer.
4 Set up, if necessary, and connect the scanner, using the
instructions in the CrownCopy section of chapter 5, “Storage
and Scanning Devices,” of your
QMS 2425/2425 TURBO Print
System Options
manual.
If You Need Assistance
If you need assistance refer to appendix A, “QMS Customer Support”
of your printer documentation for information on how to contact QMS.
Trademarks
QMS, the QMS logo, Crown, and the Crown seal are registered trademarks of QMS,
Inc., and CrownCopy is a trademark of QMS, Inc. This document is Copyrighted 1997
by QMS, Inc., One Magnum Pass, Mobile, AL 36618. All RIghts Reserved. This docu-
ment may not be copied in whole or in part, nor transferred to any other media or lan-
guage, without the express written permission of QMS, Inc.
1760177-001B
  • Page 1 1
  • Page 2 2

QMS CrownCopy Stand Install Manual

CrownCopy Stand
QMS
Brand
QMS
Model
CrownCopy Stand
Type
Install Manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents