Crown QMS, CrownCopy Stand Install Manual

Hello! I am an AI chatbot trained to assist you with the Crown QMS Install Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

QMS CrownCopy

™

Stand Installation

Introduction

The copy stand is made of a strong, clear acrylic that allows you to

place the CrownCopy scanner above the QMS 2425/2425 TURBO

Print System.

Printer Front

Stackler

Copy Stand

CrownCopy

Scanner

Printer

Back

Slots that the

Copy Stand clips

into (upper-left

side of printer)

Installation

Use the following procedure to install the CrownCopy stand:

1 Unpack the copy stand.

▲ Caution:

Do not lean or place any object over 40 lbs (18.6 kg) on

the upper shelf of the stand.

2 Place the copy stand on top of the printer, ensuring that it

clips down into the slots located on the upper-left side of the

printer.

3 Place the scanner on the stand with its interface ports facing

the back of the printer.

4 Set up, if necessary, and connect the scanner, using the

instructions in the CrownCopy section of chapter 5, “Storage

and Scanning Devices,” of your

QMS 2425/2425 TURBO Print

System Options

manual.

If You Need Assistance

If you need assistance refer to appendix A, “QMS Customer Support”

of your printer documentation for information on how to contact QMS.

Trademarks

QMS, the QMS logo, Crown, and the Crown seal are registered trademarks of QMS,

Inc., and CrownCopy is a trademark of QMS, Inc. This document is Copyrighted 1997

ment may not be copied in whole or in part, nor transferred to any other media or lan-

guage, without the express written permission of QMS, Inc.

1760177-001B