CyberData 011443 Owner's manual

Brand: CyberData

Model: 011443

Type: Owner's manual

The IP Endpoint Company

Prepare Hole on Drywall

Hole Size: 5.5" [140mm] x 5.5" [140mm]

Place Inner Mount Over Wall Cutout

Mark Hole Center with Pencil / Marker

Drive Provided Self-Drilling Plastic Anchor (4 Pieces)

into Drywall with a Phillip Screwdriver

Note: For Best Results, Hammer Plastic Anchors

in to Drywall then Use Screwdriver

Install Assembled Backbox and Inner Mount

with Provided Flat Head Self-tapping Screw (4 Pieces)

Remove Hole Plug Assembly from Gang Box

if Wire and Cable are Come in from Side

Install Ground Wire to Ground Lug

Lug

Install Inner Mount with Provided

Flat Head Undercut Machine Screw (4 Pieces)

Remove Faceplate Assembly from Backbox

Save Mounting Screw for Later Use

Ground

Drywall Drywall

Phillips Drive

Screwdriver

Self-Drilling

Plastic Anchors

Faceplate Assembly

Mounting Screw

Backbox

Adhere Provided Gasket on to the Back of Flange Mount

or Silicone Weatherproof Sealant (Not Provided)

Gasket

Mounting Screw

Faceplate Assembly

Mount

Flange

Gasket

Inner Mount

New Design

Using Old Design Flange Mount

Will Required to Clip o Extra Pegs on the New Gasket(Circled)

Piror Install on to the Flange Mount

Old Design Flange Mount

New Design Flange Mount

Inner Mount

Old Design

Pegs Through Hole

Installation Quick Reference

Flush Mount Kit, 1X

011443

STEP 1 STEP 2

STEP 3

STEP 5

STEP 6

STEP 7

STEP 4

CyberData 011443 Owner's manual

CyberData 011443 Owner's manual

CyberData 011443 Owner's manual

Related papers

Other documents