TMI Products 1964-72 Mustang Sport Door Panel Installation guide

Type
Installation guide
Sport Door Panel Instrucons
Tools Needed:
1.Adhesion Promoter 4.Phillips Screwdriver 7.Rag
2.Rubbing Alcohol 5.Self Tapping Screws 8.Plasc Trim Tool
3.Double Sided Tape 6.1/8 inch Drill Bit
Step 1.
If you are installing the Standard
equiped door panel,refer to step 1.b.
However, if you have a Deluxe Style Door
Panel, now begin to remove stock door panel.
Step 1.b
Using the Drill Hole Template supplied on Page
4, poke holes through the indicated holes pointed
out by the arrows. Now hold Drill HoleTemplate
against the door panel directly over the holes
depicted in Figure 11. With a marker, mark two
dots where you previously poked through the Drill
Hole Template. Now proceed to drill a 1/8th inch
hole on each marked dot.
1. 2.
3.
4.
5. 6.
7.
8.
MUSTANG-SPORT-DOOR PANELS
Be Sure to wipe thoroughly with
cleaning substance
Rubbing
Alcohol
Figure 1.
Figure 2.
Table Of Contents
Step 3.
Install supplied double-sided tape to top of door
panel, make sure to trim excess tape from the
the door. Slice through red plasc and then pull
three inches o the double sided tape towards the
outside of the door panel. (Make sure window is
rolled down during this installaon step)
1.Install doublle-sided tape
2.Properly align tape to door
panel
3. Slice through red plasc tape and then pull three
inches o the double sided tape.
Step 4 .
Now remove double sided tape, one side at a
me. (Remove Carefully) With rag, wipe down the
top of the new door panel and align . Sck door
panel to tape.
Step 5
Step 6
Step 2.
Clean the top rail of the door panel with
adhesion promoter or with rubbing alcohol.
Figure 3.
Figure 4.
Figure 5.
Figure 7.
Figure 8.
Figure 9.
Figure 10.
Figure 11.
  • Page 1 1
  • Page 2 2
  • Page 3 3

TMI Products 1964-72 Mustang Sport Door Panel Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI