Fluidmaster 5104 Installation guide

DO NOT USE:

STEP 1

STEP 2

INSTALLATION INSTRUCTIONS

:DEDEEN SLOOT

1. Turn off water supply. Flush toilet to drain tank.

2. Disconnect old flapper chain from tank lever arm and flapper.

3. Attach "C" clip end of new chain to flapper, tighten clip

if necessary.

4. Connect long clip side of chain to hole in tank lever arm that

provides the best lift. Chain should have slight slack when in

closed position. Turn on water supply and check flush.

If a new flapper is needed, use Fluidmaster Model 500, 501,

502, 503, 504 or 555C.

30800 Rancho Viejo Road

San Juan Capistrano, CA 92675 U.S.A.

www.xthistoilet.com

instructions, which may be found at www.fluidmaster.com. Fluidmaster, Inc. shall not be

liable for any damages resulting from failure to install or maintain the product in accordance

with the product instructions, from abuse or misuse of the product, from use of

non-Fluidmaster, Inc. parts, or from overtightening. Do not use in-tank drop-in toilet bowl

cleaners containing bleach or chlorine.