Slim Light Features:

Motion/Light Sensor: Light instantly turns on when it

detects motion from up to 7 feet away. The light sensor

conserves battey life by preventing the light from

activating in daylight.

Auto Shut-o: Light shuts o automatically after 20 or 60

seconds (optional) if no motion is detected.

Bright LED: 35 Lumens covers up to 10 sq ft.

600 Beta Drive, Unit 100, Mayeld Village, OH 44143

• 2 Slim Lights

• 4 Screws & 2 Strips of Double Sided Tape

• 2 Mounting Brackets

Motion &

Light Sensor

Mounting Bracket Motion Sensor Sticker

LED Light

NOTE: Light sensor only allows Slim Light to activate in darkness. We recommend you test in a dark room or closet.

What you need to install:

Thank you for purchasing the Mr Beams

provide light where you need it at a very

reasonable cost.

What is included per light:

www.mrbeams.com

1. Remove rear cover of light by placing two

ngers on the circle on the face of the light and

placing your thumbs on each side of the back of

the light, lightly push down and slide toward the

arrows on mounting bracket.

3. Insert 4 AA-Cell batteries into Slim Lights. Lights should come

on immediately. Do not replace cover.

4. Drive screws (included) through holes of mounting bracket to

secure.

Tips:

Use only new alkaline AA-Cell batteries with 1.5V rating.

Do not mix old and new batteries. If batteries are not new, it may cause the light to malfunction.

Install batteries with polarity in correct position.

Light may activate when batteries are inserted. Simply take light into a dark room. Allow

NOTE: This is a strong adhesive tape that may cause damage to paint,

wallpaper, or surface underneath if removed.

Battery Caution:

1) Do not mix old and new batteries

2) Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium)

or (Nickel Metal Hydride) batteries

3) Do not dispose of batteries in re