Kolpin 98005 User manual

Rev. 2

98005 – Thumb Buddy

Mounting Specific Instructions:

1. Place the Thumb Buddy over your existing throttle on your ATV.

2. Place the ¼” Truss Head Bolt through the holes in Mounting Base. Tighten enough to

hold the Thumb Buddy on your throttle.

3. Check the location of your new Thumb Buddy. You can slide the Thumb Buddy Section

outwards to obtain more leverage.

4. Once proper location is achieved tighten down the Mounting Base securely to the OEM

throttle.

5. Place the Rubber Caps over the extra threads that protrude out past the backside of the

Mounting Base.

**Warning** - With the machine off, check the function of your Thumb

Buddy. You may have to cut your handle bar grips to ensure there is no

interference when using the Thumb Buddy. Your throttle could become “stuck”

open and could result in serious injury or death!

NO. DESCRIPTION QTY.

1 MOUNTING BASE 1

2 THUMB Buddy 1

3 ¼” TRUSS HEAD BOLT 2

4 ¼” LOCK NUT 2

5 RUBBER CAP 2

Kolpin Outdoors, Inc.

205 N. Depot Street, Fox Lake, WI 53933

Phone #: (877) 9KOLPIN or (920) 928-3118

www.kolpinpowersports.com

Interference – Trim with

knife or scissors!