Page is loading ...
2400W Vacuum Cleaner 8845 Instructions
Please read carefully before use and retain
for future reference.
Handle
Air intake control slide button
Crevice tool
Round brush
Steel extension tube
Hose
Floor brush
Filter cover
Power switch
Dust full indicator
Hose vacuum connector
Speed control slide button
Fore cover release button
Carry-handle
Cable winding button
Warning
• Read the instructions carefully.
• This unit is for domestic use only. Use as
described in this instruction booklet.
• Before using the unit, check that the mains
power voltage corresponds to the voltage shown
on the rating plate.
• Do not use the unit to
vacuum liquids, sharp items
such as broken glass, hot ash
etc.
• Keep the vacuum cleaner
away from stoves and heat-
emitting appliances. Heat
can deform and discolour
the plastic parts of unit.
• Do not block the flow of air.
Blocking suction or allowing
dust to clog the hose will
decrease the efficiency.
• Do not run the unit over the
power cable.
• Always remove the plug
from the power socket when
the unit is not in use and
before carrying out any
cleaning or maintenance
operations.
• Check the hose before use.
• If the supply cord is
damaged in any way do not
use.
• Never use spirits or other
solvents to clean the unit.
Only use a damp cloth and
surface wipe clean only
• Never leave the unit unattended when it is
switched on. Keep the unit out of the reach of
children or the infirm.
• Do not use the unit without a dust bag or filters.
Empty regularly for optimum performance.
How to use
1. Ready for use
Connect the extension tube to the hose and
connect to the main body of the vacuum. Fix your
chosen brush to the steel tube.
2. Operation
• Before using the unit, unwind the cable and
insert the plug into the power socket. A yellow
mark on the power cable shows the ideal cable
length. Do not extend the cable beyond the red
mark.
• Press the ON/OFF button to
switch the unit on. Press it
again to turn off.
• Slide the air intake control
button on the handle to
adjust the suction. The
greater the air intake the
smaller the suction.
• Choose a suitable suction
according to the surface to
be cleaned. Also adjust the
speed control slide button.
• For carpet use minimum air
intake for powerful suction.
• For hard floors use medium
air intake for normal suction.
• For fabric, curtains, sofas etc.
use maximum air intake for
soft suction.
3. Using the cleaning
accessories
• On the Floor brush there are
2 settings. Press down the
button with mark “ ”and
then use the brush with the
bristles extended for hard
floors.
• Press down the button with
mark“–”and then use the
bristles retracted for carpet.
2. Installing the dust bag
• Slide the plastic support
onto the top of the dust
bag. Position the dust bag
correctly in its
compartment.
3. Cleaning the filter
• If the filter is dirty, remove
the filter.
• To clean or replace the air
outlet filter, first detach the
grille by pulling firmly away
from the appliance.
• Remove the HEPA filter by
opening the HEPA cover in
the base.
• Wash carefully in liquid or
water. Allow the filter to dry
completely before replacing it.
Notice: Neither wash the
cloth bag in washing machine
nor dry it by electric heater,
instead wash it in warm water
and dry in natural air.
4. Clean the unit and
accessories
• Do not clean the body of
vacuum cleaner with
anything other than a barely
damp cloth.
• Clean the debris adhering to
the floor brush with an old
toothbrush every month.
5. Storing the vacuum
cleaner
• Plug the orientation pin on
the floor brush into the
orientation hole in the main
body.
• Round brush for cleaning
smaller areas such as stairs.
• Crevice Tool for cleaning
edges and hard to reach
places.
4. Turn off the appliance
and wind in the cable
• Each time after cleaning,
press the on/off switch first
and then remove the power
plug from socket. To rewind
the power cable, press the
rewind button with one
hand, and guide the cable
with your other hand to
ensure that it does not
cause damage when
winding in. It will wind quite
quickly!
Protective Device
• The indicator will become red when the air flow
is obstructed or the dust bag is full. At that time,
you should shut off the power, and clean the
blockage or empty the dust bag. Then switch it
on again. It is normal when the indicator is
green.
How to maintain
1. Emptying the dust bag
• After removing the hose, open front cover by
pressing the button and pulling upwards.
• Press the dust bag button
backward and remove the
dust bag.
• If the fabric bag is not in
good condition, slide the
plastic support from the top
and dispose of the dust bag. Additional bags are
available to purchase from Customer Services on
0844 482 4400 or www.coopersofstortford.co.uk
(while stocks last). Item code 8847.
• If the cloth bag is still ok, slide the plastic
support from the top and empty.
Troubleshooting
Problem Cause Resolve
Motor doesn’t The plug is not Plug in and
work plugged in or switch on
switched on
Suction decrease The filter is Clean it
blocked
The bag is full Replace the bag
or empty the bag
The flexible hose Check and clear
or extension tube all blockages
is blocked
Unit heats Getting warm is normal. If the heat is
excessive, turn off immediately and
discontinue use
Technique parameter
Model No. Power Voltage Frequency
8845 2400W 220-240V 50-60Hz
Packaging
Dispose of the packaging at your local recycling centre.
Dispose of paper and card separately from plastic bags at
your local recycling centre.
Dispose of the item at the end of its lifespan at your local
authorised household waste recycling centre.
DECLARATION OF CONFORMITY
We, The Enterprise Department Ltd.
Of 11 Bridge Street, Bishop’s Stortford,
Hertfordshire, UK. CM23 2JU
in accordance with the following Directive(s):
Electromagnetic Compatibility 2004/108/EC
EN 55014-1:2006+A1:2009+A:2011
EN 55014-
2:1997+A1:2001+A2:2008
EN 61000-3-
2:2006+A1:2009+A2:2009
EN 61000-3-3:2008
Low Voltage Directive 2006/95/EC
EN 60355-2-
2:2010+A11:2012+A1:2013
EN 60335-1:2012
EN 62233:2008
2400W Vacuum Cleaner
Model number: 8845 ( H5501)
Hereby declare that the equipment named above
has been designed to comply with the relevant
sections of the above referenced specifications.
The unit complies with all applicable Essential
Requirements of the Directives.
Mr. Stuart Fowler
Imports Director
December 2013
/
