protech TD2082 User manual

Brand: protech

Model: TD2082

Type: User manual

LCD Type Engineers Calipers

TD2082

User Manual

Technical Specifications

Measuring Range:

0 – 150mm / 0 – 6in

Resolution:

0.01mm

Accuracy:

0.02mm / 0.001in (<100mm)

0.03mm/0.001in (>100mm – 150mm)

Repeatability:

0.01mm/0.0005in

Max measuring speed:

1.5m/sec, 60in/sec

Measuring system:

Linear capacitive measuring system

Display:

LCD display

Power:

1 x LR44 1.5V

Features

1. External measuring jaws

6. IMPERIAL & metric scale

11. Thumb Roller

2. Internal measuring jaws

7. Battery compartment

12. On/off switch

3. Depth blade

8. Output connector

13. Zero switch

4. Step measuring faces

9. LCD Display

14. Imperial & metric conversion switch

5. Beam

10. Slider clamp screw

Applications

1. Operation:

Slider can be removed only after the locking screw (#10) is loosened.

2. Basic measuring methods:

1) Loosen the locking screw

2) Press “on” button, select imperial or metric by pressing “mm/inch” button.

Pressing “mm/inch” button after measurement will display the imperial/metric conversion.

3) To reset display to zero, close external measuring jaws, then press “zero” button.

Maintenance instructions

1. Keep the calliper clean and dry (liquid can damage the slider)

2. Use a clean, dry cloth to clean all surfaces – do not use solvents or solvent based cleaners.

3. To save power, turn of the unit when not in use.

4. Avoid contact with electricity and/or electronic devices.

Battery replacement

A flashing display indicates the battery is low. To replace the battery, remove the battery cover by

sliding the cover in the direction indicated on the cover and replace the battery with the positive

side facing outwards.

Troubleshooting

Failure

Issue

Solution

Display flashes

Low battery

Replace battery

Display does not change when

slider is moved

System locked

Perform a system reset by removing

the battery for 30 seconds.

Accuracy less than + / -

0.001mm

Dirt in the sensor

Remove slider cover and its assembly.

Clean with compressed air.

No display on LCD

1. Improper battery

position

2. Low battery

1. Remove battery cover and check

battery position

2. Replace battery

Distributed by: TechBrands by Electus Distribution Pty. Ltd. 320 Victoria Rd, Rydalmere, NSW 2116 Australia. Ph: 1300 738 555 www.techbrands.com Made in China

protech TD2082 User manual

protech TD2082 User manual

protech TD2082 User manual

Other documents