Too Cute Beads Petite Starlight Leather Bracelet Kit User manual

Petite Starlight Bracelet Kit

See page 2 for step by step photos

(images 1-3)

Begin by cutting your leather in half.

Next, at a very sharp angle cut the ends of your

leather to points

Glue your ﬁrst two end caps on and let dry.

(Images 3-6)

Now we’re ready to load our button.

Lineup your holes pushing in the button slider

(Image 7)

Check your sizing. You may need to trim down

your leather. Glue in your other end caps.

(Images 8-9)

Open your jump ring and attach it to your end caps and then load one end of your chain

and one end of your magnetic clasp.

Close your jump rings, and repeat on the other side.

For easy re-order, scan this QR code with your phone