CTA LT-SAM Laptop Security Arm User manual
- Category
- Flat panel desk mounts
- Type
- User manual
Home » CTA » CTA LT-SAM Laptop Security Arm with VESA Mounting Base Instruction Manual
Contents
1 CTA LT-SAM Laptop Security Arm with VESA Mounting
Base
2 Package Contents
3 INSTALLATION
4 Connecting the Holder to the Laptop Plate Base
5 Connecting the Laptop Holder Plate Base to the VESA
Joint
6 Installing your Laptop to the Holder Plate Base
7 Adjusting Joints
8 Documents / Resources
9 Related Posts
CTA LT-SAM Laptop Security Arm with VESA Mounting Base
CTA LT-SAM Laptop Security Arm with VESA Mounting Base
Instruction Manual
Manuals+ — User Manuals Simplified.
Package Contents
INSTALLATION
When installing on a Flat Surface:
1. Place rubber grip flat insert into the clamp groove. Rotate to loosen handle counter-clockwise to widen around
surface ledge.
Rotate clockwise to tighten until secure.
When installing on a Pole:
1. Remove rubber grip flat insert from clamp groove. Rotate to loosen handle counter-clockwise to widen around
surface ledge.
Rotate clockwise to tighten until secure.
Connecting the Holder to the Laptop Plate Base
Take the laptop holder and align the holes on the bottom of the middle joint to the holes on laptop plate as shown.
Using the provided tool, screw in the screws from below into the bottom of the laptop holder joint until securely
tightened.
Connecting the Laptop Holder Plate Base to the VESA Joint
Align the VESA holes of the laptop plate with the VESA mount as shown. Using the provided tool, screw the (4)
screws from above the plate through both the plate and VESA mount while holding the (4) hex nuts from behind
with your hand. Keep screwing until tight and secure.
Installing your Laptop to the Holder Plate Base
1. Unlock the holder with the key, and pull out the lock component to allow the holder to adjust.
2. Extend/Retract the holder to fit the laptop as shown.
3. Once the laptop holder is secure, push the lock component back in, and rotate and lock the holder on the back.
Adjusting Joints
1. Turn the knob counterclockwise to loosen any of the joints on the vehicle mount. Adjust the arm to the deesired
angle and position, then rotate clockwise to tighten and secure the position
2. Adjust and rotate middle joint to orient your laptop as needed as shown
3. The connection of the higle of the holder allows you to adjust your Laptop screen angle. Using the provided
allen key, you can loosen and tighten the coonection as needed.
Documents / Resources
CTA LT-SAM Laptop Security Arm with VESA Mounting Base [pdf] Instruction Manual
LT-SAM, Laptop Security Arm with VESA Mounting Base
Manuals+,
-
1
-
2
-
3
-
4
-
5
CTA LT-SAM Laptop Security Arm User manual
- Category
- Flat panel desk mounts
- Type
- User manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Samsung QB49R User manual
-
-
Vivo STAND-V012L Assembly Instructions
-
Motorola MW810 Installation guide
-
-
Anthro 615SM Datasheet
-
Ergotron 47-057-180 Datasheet
-
-
-