R51 EXT51KIT

HOUSE OF ROHL R51 EXT51KIT User manual

  • I have reviewed the instruction manual for the R51 EXT51KIT. This manual provides instructions on how to install the extension kit which involves preparing the system, adding the extension piece and securing all components. I’m ready to answer your questions about the device and its installation process.
  • What is the first step in the installation process?
    What should I do before installing the new puck extension?
    What is the final step for the cartridge nut housing?
INSTRUCTION MANUAL
MANUEL D’INSTRUCTIONS
MANUAL DE INSTRUCCIONES
R51 EXT51KIT
1. Turn off stops and remove the cartridge. To remove your trim set, refer to
original installation guide. 1. Turn off stops and remove the cartridge. To remove
your trim set, refer to original installation guide. 1. Turn off stops and remove
the cartridge. To remove your trim set, refer to original installation guide.
INS12920 - Rev. 06/22
For warranty or additional
information, contact: US Customers
houseofrohl.com/support
1-800-777-9762
Canadian Customers
houseofrohl.ca/support
1-866-473-8442
1-800-287-5354
2. Install centering pins and new bottom cavity gasket into the extension. 3. Install the new
puck extension and the balancing spool and cartridge into place. 4. Install cartridge nut housing
by hand tightening and apply a 1/4 turn with a wrench. Do not overtighten.
2. Install centering pins and new bottom cavity gasket into the extension. 3. Install the new
puck extension and the balancing spool and cartridge into place. 4. Install cartridge nut housing
by hand tightening and apply a 1/4 turn with a wrench. Do not overtighten.
2. Install centering pins and new bottom cavity gasket into the extension. 3. Install the new
puck extension and the balancing spool and cartridge into place. 4. Install cartridge nut housing
by hand tightening and apply a 1/4 turn with a wrench. Do not overtighten.
/