RIVER 20789 User manual

ASSEMBLY INSTRUCTION

CAUTION - Refer to the wattage caution label located near the lamp holder for maximum

wattage - do not exceed the maximum wattage.

WARNING - Do not attempt to replace the bulb(s) while the lamp is plugged into a wall

receptacle

CARE INSTRUCTIONS - Use only a soft cloth; do not use any chemicals or abrasive cleaners.

IMPORTANT SAFETY INSTRUCTIONS

MADE IN CHINA

1. Attach the mounting bracket(F)to the outlet box by using two

mounting screws(G).

2. Pull out the outlet wires and housing grounding wire from the

outlet box. Make wire connections using the wire nuts (E):

--WHITE wire with WHITE-NEUTRAL

--BLACK wire with BLACK-LIVE

--Attached the fixture grounding wire to mounting bracket

with green grounding screw(D). Carefully tuck the wires back

into the outlet box.

3. Secure the canopy to the metal mounting bracket (F) with

screws provided (H).

4. Attached the lamp shade(B) to the lamp holder, then secure it

with socket ring(C).

Important Note: Socket ring comes pre-assembled

and is located on the socket.

5. Install the bulb I(not included).

E12 Type B.40W X 3 (Not included)

E12 CFL 7W X 3 (Not included)