BeloonDecor Mini Hot Air Operating instructions

Inflate and Deflate Instructions

Easy to follow instructions.

Inflation Directions:

1) Air bladders arrive either already inside or outside the cloth cover. If outside, place inside the cloth

cover first. The nozzle can be aligned at the center of the bottom or at the top with access through the

cover.

2) We have included a small hand pump, with a needle nose attachment to inflate the air bladder.*

3) Insert needle tip into valve and pump.

4) Be sure to fill the Be’loon fully until no creases or wrinkles are seen on the air bladder.

5) If you plan to locate the Be’loon in direct sunlight, release a little bit of air. The direct sunlight will

cause the air to expand slightly and deflating the bladder slightly will adjust for this.

6) Over time, some bladders might lose some air. Simply refresh your Be’loon with a few pumps of air to

full in no time flat!

*the air bladder can be inflated bicycle pump or electric air compressor as long as a needle nose

attachment is used.

Deflation Directions:

1) Insert needle nose attachment from handpump provided or any other piece of equipment. Once it

is inserted all the way, air will withdraw from bladder.

Reminder:

When displaying the Be’loon in direct sunlight, underinflate the Be’loon to allow for the air to warm up

inside and expand. A release of 2 to 3 seconds will be enough time and enough air to escape. Fill the

Be’loon full so that there are no wrinkles in the cloth cover then release just a few seconds of air.

If your Be’loon is not going to be hung in direct sunlight, then there is no reason to under inflate.