NECPLBGN

Neptune NECPLBGN Installation guide

  • Hello! I've reviewed the installation manual for the Neptune NECPLBGN and NECPLBWH fire alarm switches. This manual provides instructions on how to install and configure the device, including the wiring, buzzer settings, and mounting options. The device features LED indicators and a resettable design, with multiple output points for other equipment. I'm ready to answer any questions you may have about this device.
  • What is the input power range for this device?
    How can the buzzer status be set?
    What is the maximum load for the output points?
NECPLBGN/NECPLBWH
Installation Manual
6.Built-in buzzer status can be set as silent, intermittent or continuous.
The volume is adjustable.
4.Reset key with non-slip design
3.The outside plate will show the status (Green or Red)
2.Press the outside plate to enable the output function
1.Resettable design, LED indicators around the edge of the unit
7.Easy to assemble, outer case has no screws, 3 sets of output points to
connect other equipment, flush or surface mount installations.
Set as silent, intermittent, or continuous
Please depress the outside plate to make sure
the indicator flag turns red before opening the
front and middle covers to prevent the spring
from popping out.
Fixing Holes for flush mount
installation are set at 60mm
Terminal opening is restricted
as shown below
Surface Mount Installation
Flush Mount Installation
Use the key supplied to dissassemble B
and C fixings
Fix the unit as shown in the diagram above
Fix bottom cover C and connect the wires
Insert the key into the key hole. Pull the key out
when the flag turns green to complete the setting
Use the key supplied to
dissassemble B and C
fixings
No bottom C cover is
required for flush mounting
Use the key supplied to
dissassemble A and B
fixings
Remove the fixing
tabs not required for
flush mounting
Fixing tabs
Fixing tabs
Fix the middle cover B
and connect the wires.
Fix the unit as shown
in the diagram above
Insert the key into the key hole.
Pull the key out when the flag
turns green to complete the
setting
Status display
1/2