7. DIGITAL DELAY DISPLAY
These jacks are for connecting microphones.
6. MIC INPUT JACKS
8. DELAY TIME SETTING SWITCH
To change the rate of the delays. Turn this knob clockwise, you will hear the signal repeat at a faster rate.
Use Up switch( ) to increase delaying time and Down switch ( ) to decrease delaying time.
9. REPEAT
14. MASTER CONTROL
This knob adjusts the final level of the Main bus which is sent to the speakers.
This knob adjusts the mix level of the effect sound which will be feed to main mix.
10. EFF LEVEL
A rotated knob to increase or lower the Hiss of the main bus signal.
A rotated knob to increase or lower the low of the main bus signal.
12. LOW CONTROL
11. HIGH CONTROL
13. TAPE VOL
This knob adjusts the level of TAPE input which is sent to the main bus.
15. MP3 PLAYER WITH LCD DISPLAY
5
2
12
6
10
8
13
7
414
SD
USB
MODE
FOL-
FOL+ U/SD
SCAN
REPEAT PLAY/PAUSE
EQ VOL-
MUTE
VOL+
1
3
11
9
(1) The LCD window displays working message of Mp3.
(5) Change Player Mode: Push this button, USB/SD/FM Radio
(7) USB/SD/S-CAN change: Under USB/SD mode, this button
is
(13) Volume - /PREV: Push this button and release, jump to
decrease the playing volume.
(2) USB socket.
(3) SD card socket.
(4) The window of remote control.
souring changeable.
(6) Play/pause button.
used to change playing via USB or SD; under FM radio
mode, this button is used for automatic channel searching.
(8) Mute Button: Under playing mode, push this button to be
noiseless, push it again to recover.
(9) EQ Button: Push this button to change EQ mode, the effect
ordinal is: CLASSICAL, BASS, LIVE, ROCK, POP.
(10) In normal condition, the player Cyclical mode of playing:
play all songs orderly; push this button, it play one song only.
(11) Forward function: Push this button, the player search the
previous file and play.
(12) Backward Function: Push this button, the player search
the next file and play.
the previous song and play; push this button and hold it,
playing volume.
(14) Volume +/ NEXT: Push this button and release, jump to the
next song and play; push this button and hold it, increase the
16. LEVEL CONTROL CH1-CH4(HQM2200B ONLY)
Adjust the output level of the channel 1-4.
3
NOTE: The ring must be grounded if the source is unbalanced.
TIP(HOT) TIP(HOT)
RING(COLD)
SLEEVE
SLEEVE
(GROUND)
(GROUND)
5. LINE INPUT JACKS
Line input accepts TRS plug with balanced or unbalanced line. It accepts all kinds of signals from
sources such as keyboards, electronic drums, tape recorder, etc. With the exception of microphone
signals. When you use unbalanced TS plug, the line input although using unbalanced TS plug
with this mixer is not recommend.
1 4
/
1 4
/1 4
/
17. TAPE IN AND LINE OUT
The TAPE IN (with RCA allows cassette recorder or CD player to the Main output.
The LINE OUT provides signal output to a cassette deck and home audio equipment.
sockets)
(with RCA sockets)