Heat-pipe refrigerator
6
·Installation instructions
When install a Heat pipe Refrigerator, ventilation should be considered seriously, please refer to the
following:
·There should be left at least 200 cm³ for ventilation
·The distance between wall and refrigerator side should be at least 20mm
·The bottom should be left at least 50mm for air owing air passing through must not be preheated
·Entire cooling system should be considered in the ventilation
·The following four pictures show four installation ways:
·This refrigerator is designed to be free standing installation only, and should not be recessed or built-in
(Fully recessed). Allow 13cm of space between the back and sides of the refrigerator, which allows the
proper air circulation to cool the heat sink.
Failure to do so can possibly cause the re.
·Place your refrigerator on a surface that is strong enough to support it when it is fully loaded.
·Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to perform properly.
·This refrigerator uses thermoelectric refrigeration technology (no compressor) and is not designed for
storage in hot areas like garages, warehouses or outdoors since it is designed to operate at a maximum of 17℃
below the ambient temperature.
·Avoid locating the unit in moist areas.
·Plug the refrigerator into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certied electrician.
·After plugging the refrigerator into a wall outlet, allow the unit to cool down for 2-3 hours before placing
5
Heat-pipe refrigerator
·Changing the Swing Hinge
This refrigerator has the capability of the door opening from either the left or right side. The unit
is delivered to you with the door opening from the left side. Should you desire to reverse the
opening direction, please follow the below instructions.
All the hinge can be used for left or right swing,except for model BCH-40 and BCH-42,please
nd an additional left upper hinge in the bag of the user manual for installation as below.
·Pull out the three screws from right hinge.
·Remove the hinge (upper and lower) away.
·Install the door in suitable position with hinges, use three self-screws to x them.
·Trouble Shooting Guide
Refrigerator does not operate
Refrigerator does not operate.
The light does not work.
Vibrations.
The door will not close properly.
Not plugged in.
The circuit breaker tripped or a blown fuse.
PROBLEM POSSIBLE CAUSE
The room temperature is hotter than normal.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The refrigerator does not have the correct
clearances.
Abnormal voltage.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The LED light has burned out.
Check to assure that the refrigerator is level.
The refrigerator is not level.
The door was reversed and not properly
installed.
The gasket is dirty.
The shelves, bins, or baskets are out of
position.